artisan Altivar 16 Series Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Controlador artisan Altivar 16 Series. artisan Altivar 16 Series 17 páginas. Speed controller for asynchronous motors

artisan Altivar 16 Series Manual do utilizador

Technical characteristics

Output voltage
Frequency range
Overtorque
Acceleration ramp
Deceleration ramp
Low speed braking
to a standstill
Speed controller
protection
Motor protection
Degree of protection NEMA 1, IP 30 (remove cover), for ATV-16U09M2 to U72N4
Ambient air
U72N4.
temperature
E
N
G
Maximum humidity
L
I
S
Altitude
H
Pollution
Standards /Certification / IEC, VDE, UL, CSA.
Recommendation

Installation : Mounting recommendations

IP30 : Remove the blanking plate from the top
of the cover. Free space is required around
the speed controller : D
IP30
Nema 1
d
18
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Maximum voltage equal to supply voltage.
0.1 Hz to 50 Hz / 60 Hz.
150 % of motor rated torque (typical value ± 5 %, from 5 to 50/60 Hz).
Linear 3s from 0 to 50 Hz / 60 Hz (automatic adaptation of ramp times
when transient torque is exceeded).
By automatic d.c. injection 0.7 In, for 0.5s if the frequency
drops to < 0.1Hz.
Supply overvoltage / undervoltage.
Phase failure : only for ATV-16...N4.
Short circuit : between output phases, between output phases and ground,
internal control supplies (+10, +24).
Overvoltage / Over heating
Thermal : I
2
.t if rated motor current = 0.9 In (rated current) of the speed controller
(from 25/30 to 50/60 Hz).
IP 30 for ATV-16U90N4.
Operating : 0 to 40°C for NEMA 1/ 0 to 50°C for IP 30, for ATV-16U09M2 to
0 to 40°C in IP 30 for ATV-16U90N4 – 0 to 50°C in IP 30 with mandatory use
of inductance VW3-A66503.
Storage : -25°C to + 70°C.
93 % without condensation or dripping water (if there is a risk of condensation
provide a heating system).
Less than 1000 m. Above that, derate power by 3% for each additional 1000 m.
Speed controller protected against dust, corrosive gas, water splashes, etc.
100 mm, d
50 mm.
D
Mount the unit vertically
Avoid placing close to any heating
equipment.