ALUZ A8-ZIZA-TAPE Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de iluminação ALUZ A8-ZIZA-TAPE. ALUZ A8-ZIZA-TAPE 11 páginas. Led tape
Também para ALUZ A8-ZIZA-TAPE: Manual (14 páginas)
Imprimir páginaZIZA
Tape
A8-ZIZA-TAPE
DRY LOCATION
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Mark location where mounting clips will be installed along reference line.
3
Use 1 mounting clip every 6" or 1 mounting clip every 4" if lightstrip is facing
out or down.
4
Always use a mounting clip at the very beginning and very end of each run.
Beginning of run
5
Lay mounting clips along reference line and pre-drill using an appropriate
drill bit for surface and screw size. Recommendation: 8/32 x 1" screw.
6
Screw MCS mounting clips to surface, securing lightstrip to surface.
ASSEMBLED END VIEW
.13"
6" for standard application
4" if facing out or down
End of run
.94"
MCS
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
WET LOCATION
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Use 1 mounting clip every 6', rounded up. Use a minimum of 2 mounting clips
per luminaire segment. For vertical applications, create a stopper at the
bottom of the run to prevent sliding.
3
Prepare for mounting by removing adhesive backing from mounting clips.
Remove adhesive backing
4
Adhere mounting clips to surface, then snap luminaire into mounting clips.
ASSEMBLED END VIEWS
.78"
.51"
MCS-WET
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 6 of 11
Mounting Clips
Adhesive surface
.78"
.90"
MCS-WET