Artsound MAT-8000 Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Misturador de música Artsound MAT-8000. Artsound MAT-8000 16 páginas. Venue mixer
Imprimir páginaMAT-8000
the MIC1 input.When disabled, MIC1 will mix with lines
1-8 and local inputs if required. This Microphone input
has been designed to give global priority over all other
inputs if enabled via the front panel. The MIC1 priority
setting is not saved when the MAT-8000 is switched off,
and will return to its default state on powered back on.
The default state of the MIC1 Priority is disabled.
6. MUSIC VOLUME
The Music Volume control knob (6) controls the selected
source (zones 1-8 and local input) input level. If the
system is used with Remote Control Panels, the Music
Volume knob will be disabled Source Music Volume level
will be controlled at the remote control panel only. for
zones where a remote control panel is connected.
7. MASTER VOLUME
The Master Volume control knob (7) will control the com-
bined MIC1 and Source Output Volume Level, if the MIC1
input has been enabled for a zone. The Master Volume
control knob will not control the Paging Console Public
Address Volume Level,or the Line 8 Source Input Volume
Level when the Line 8 Source Input Priority Function is
enabled. This function has been designed as a global
BGM input if required.
8. MIC1 VOLUME
The MIC1 Volume control knob (8) will control the MIC1
input level if this global mic has been configured to
operate within the zone.
9. MONITOR ZONE SELECT
The ZONE SELECT button (9) is used to select one of the
8 zones to be monitored. Pressing the zone select button
will cycle through all zones in sequence as follows: 1, 2,
3, 4, 5, 6, 7, 8, and OFF.
A zone can be selected pressing the ZONE SELECT
button. Once the display shows the desired zone,
press the ENTER button to confirm and change to the
selected zone.
Note:
The zone will only change after the ENTER button is
pressed, otherwise the source selection will be returned
to its previous setting after 10 seconds.
The monitor zone function enables the audio output from
a zone to be monitored through a small speaker on the
front panel. This is particularly useful when controlling
the audio in a remote zone or testing the system.
10. MONITOR ZONE LED DISpLAy
The Single Digit Monitor Zone LED Display (10) will
display the selected zone numbers,1-8.
11. MONITOR ZONE OUTpUT LEVEL
The 5 LED Monitor Zone Output Level Meter (11) will
provide visual indication of the audio signal level for a
selected zone.
6
12. MONITOR VOLUME
The Monitor Volume control knob (12) will control
the in-built Monitor Speaker volume level.
13 ESC
The ESC button (13) is used to cancel the selection of
source select,monitor zone select and BGM function
buttons.
14. ENTER
The ENTER button (14) is used to confirm selection of
source select,monitor zone select and BGM function
buttons.
15. BgM ALL
The BGM ALL button (15) is used to select the same
source for all 8 zones simultaneously. To confirm the
BGM ALL selection,press ENTER.
Note:
The BGM ALL selection will only be confirmed after the
ENTER button is pressed ,otherwise the source selection
will be return to previous setting after 10 seconds. In the
event power is lost, the BGM ALL selection settings will
be saved and the unit will return to the previous BGM ALL
setting when powered back on.