Asko D3532FI Manual de instruções de instalação - Página 9

Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça Asko D3532FI. Asko D3532FI 13 páginas.

Imprimir página

ADJUSTING THE LEVELING LEGS

Now that all the connections are made and the machine

is in place under the cabinet, you should make the final

height adjustment.

1. You should set the

rear foot first. To do

this,

use

screwdriver to rotate

the adjusting screw

on the bottom front of

the machine. Turn the

screw clockwise to

raise the foot and

anticlockwise to lower it.

FASTENING THE DISHWASHER TO THE CABINET

It's necessary to fasten the dishwasher to the cabinet

so it won't tilt when the door is opened or if something

heavy is placed on the door. Use only the stainless

steel screws provided with the machine.

Use option A for U.S. or European standard

installations. Use option B only for European

standard installations.

Cover the screw heads with the

plastic plugs provided with the

machine.

When the machine is properly

attached, check that the feet are

tight against the floor and that the

machine is level.

INST

INSTALLING

ALLING THE

ALLING

INST

ALLING

Once you have the toe kick bracket in place, you can

install the toe kick, as follows:

If you have not done so, take the toe kick and felt

insulation from the top of the machine-packaging.

Lay the insulation on the back side of the toe kick to

make sure it fits properly.

Peel the adhesive protection strip off the insulation

and press it firmly to the back side of the toe kick,

making sure you don't cover any slots on the toe

kick.

Positioning the notches on the toe kick at the edge

of the access panel, slide the toe kick up behind

the access panel then let it slide to the floor.

Screw the toe kick to the toe kick brackets.

Adjust the toe kick depth.

Mounting

Screws

THE T T T T T OE KICK

THE

OE KICK

THE

OE KICK

2. Using a 1/2" (12 mm) wrench, adjust the locking

nuts until the machine is

level. (The machine may

have an inclination of 2°

maximum without affecting

its performance.)

3. When the feet are properly adjusted, tighten the

locking nuts to the base pan.

NOTE:

When adjusting the unit lower than 33-1/4" (845

mm), the holes on the toe kick will need to be

elongated. An accessory toe kick is also

available for this type of installation. Contact

your dealer to order.

NOTE:

Option A can be used for U.S. or European

installations. Use option B for European

standard installations only.

NOTE:

When it is not possible to attach the dishwasher

to the cabinet, you should install tip guards.

(See "Tip Guards" on page 2.)

SETTING THE TOE KICK

DEPTH

Press the grey catches

toward each other to

release the bracket.

Pull out the holders as

far as required.

Press in the catches so

that they lock the

brackets in place.

Hang the kick-plate onto the holders by inserting it

into the grooves.

ADJUSTING THE TOE KICK

HEIGHT ON D3251/3252FI AND

D3531/3532FI

These models come with a European kickplate.

Page 9