Asko HI18611 Manual de instruções de utilização - Página 15
Procurar online ou descarregar pdf Manual de instruções de utilização para Hob Asko HI18611. Asko HI18611 20 páginas.
Imprimir página
For the fitter
Electrical connection
These hobs must be connected to the
mains using a socket in compliance with
publication IEC 60083 or an all-pole circuit-
breaker device in compliance with the
installation rules in force.
When power is first supplied to your hob,
or after an extended power cut, an
indicator light will appear on the control
panel. Wait for 30 seconds approximately
until this information disappears before
using your hob (This display is normal and
it is intended, if applicable, for your after-
sales service. In all cases, the user of the
hob should disregard it).
Hook-up of 220-240V~
Black-grey
Blue
Brown
L
N
32A
Blue
Brown
N L
16A for model 803HI16611
32A for model 803HI18611
Hook-up of 400V 2N~ - 16A
Separate the 2 phase wires (L1 and L2)
before connection.
For a 400 V 2N triphase connection, if your
hob malfunctions, check that the neutral
conductor is properly connected.
Warning
If the power cable is damaged, it
should be replaced by the
Green/yellow
manufacturer, its after-sales service
department or by a qualified person to
avoid danger.
Warning
The safety wire (green-yellow) is
connected to the appliance's terminal
ground lead of the electrical set-up.
Green/yellow
In the case of connection to an electric
wall socket, it must remain accessible
after installation.
The fuse in your set-up must be
10 amperes.
If the power cable is damaged, it must
be replaced by the manufacturer, its
After-Sales Service Department or a
similarly qualified person to avoid
danger.
Black-grey
Brown
Blue
L1 L2
N
Neutral
Live
and must be connected to the
Green/yellow
Earth
13