AME MM-1 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильная сигнализация AME MM-1. AME MM-1 15 страниц.
Также для AME MM-1: Руководство по установке (6 страниц), Руководство по установке (14 страниц)

Руководство пользователя

AME MM 1 Автомобильная охранная система

Directions for Use

Main Alarm Functions

Arming

With all door, hood, trunk closed and with the ignition off press button 1 once to arm the alarm system.

When the alarm is armed and the doors lock the siren will beep once and the indicators will flash once, the LED

will flash slowly to indicate that the system is armed.

Defective Zone Warning

If any door, trunk, or hood is not shut properly while arming the siren will emit three additional beeps and the

indicators will flash three times.

Dome Light Car Detection

This feature can be selected using programming.

If the interior light in your car includes a delay when the door is closed turn this function on, there will be no

additional warning beeps on arming the alarm system with the interior light left switched on because of the timed

delay.

Armed

When the alarm system is armed and triggered it will be triggered for 30 seconds or until you press any

transmitter button or enter the override code (PIN code) once any door, hood or trunk is opened or the shock

sensor (or optional sensor) is triggered. If the pre warn zone of the shock sensor (optional sensor) is triggered, this

will cause the siren to emit a few short beeps.

Disarming

When the alarm is armed press button 2 once to disarm the alarm system.

When the alarm system is disarmed, the siren will chirp three times, the indicators will flash twice, the LED will

turn off and the central door locking will unlock.

2 Stage Disarm

To disarm the alarm system normally, press the disarm button. If the alarm system has been triggered, pressing

a button will stop the alarm cycle but the alarm system will remain armed and the doors will remain locked (if the

action causing the trigger is over i.e. door open triggered alarm but the door is now closed). If the action causing

the alarm trigger is not over i.e. the door is still open then it will require two presses of a button to stop the alarm

cycle. The alarm will remain armed with the doors locked. To fully disarm the alarm system, press the disarm button

(2) again.

Panic

Holding buttons 1 and 2 pressed for 3 seconds will activate panic mode. The siren will sound and the indicators

will flash until you press button 1 again to turn off panic mode. When the panic mode is activated the alarm system

will keep status (armed or disarmed) it held before.

Silent Arm

Pressing button 2 immediately before button 1 is pressed (within 3 seconds) will arm the alarm system without

beeping the siren unit. All other features including the indicator flashes will remain the same. Note: If the alarm is

giving the driver a warning such as three beeps for door/hood/trunk open the alarm system will beep the siren even

if it is overridden by the remote or the software switch. Fault warnings take priority over silent arming.

User's Guide

AME MM 1 Car Alarm System