Air Armor M240 Руководство пользователя - Страница 2

Просмотреть онлайн или скачать pdf Руководство пользователя для Воздушный компрессор Air Armor M240. Air Armor M240 2 страницы. Special ops

Печатать страницу

Extra Caution:

Small items will inflate quickly and can easily be damaged.

Pay special attention to bicycle tires. They inflate very fast

and can rupture.

Be prepared to stop the unit quickly when manufacturer's

recommended inflation pressure is reached

Operation Set-Up:

When operating the unit, be sure to be in a safe location off

of the roadway and away from traffic. Place the unit on a dry

level surface. Unpack the unit and inspect for damage. Fully

unwrap the power cord. Be sure to install the air filter.

Connect the air supply hose to the unit using the quick

connect fitting.

1. Slide retaining snap ring back.

2. Slide the fittings together firmly.

3. While holding fittings together firmly slide the outer ring

forward to lock.

Power Cable Connection:

Once again it is strongly recommended you follow your

vehicles jump starting instructions for proper cable

placement. Sparks are the enemy.

Red

Positive

Connect the

power clip to a

Black

Negative

Connect the

power clip to a

Test the connections by switching the compressor to "on."

Air will begin to flow.

Connect the air chuck onto the tire valve stem.

Watch the gauge closely, switch the unit off or remove the

inflator from the tire when the manufacturer's recommended

pressure has been achieved.

We recommend that you use a second tire pressure gauge

to verify your tires are inflated to the proper pressure.

Stopping and restarting: at high pressure can overload and

trip the fuse. At higher inflation pressures, start the unit and

then attach to the filler to the tire valve stem. If you stop the

unit and need to resume inflation, remove the inflator tip from

the tire valve, start the unit and reattach with the unit

running.

After use store the battery cable neatly in the gauge side of

the compartment. Carefully coil the air supply hose and

store.

Store the unit in a dry location.

Operating Hints:

We don't recommend using this unit with an air tank

configuration; if you do it will void the warranty.

Switch the compressor on before connecting to the tire in

order to reduce stress on the motor.

We recommend an on\/off cycle time of 20 minutes rest/off

for every 40 minutes of run time.

You can use additional sections of air hose. Keep in mind

that this unit must have a free flow of air when in use. DO

NOT DEAD END THE HOSE.

Troubleshooting:



If the unit stops during operation:

1. Check the battery condition and your connections..

2. Check the fuse and replace if necessary. Low voltage can

blow the fuse.

3. The unit is equipped with an automatic thermal protection

12 volt source.

device. In the event the unit reaches an unsafe operating

ground point.

temperature, a protection circuit will cut power to prevent

damage to the unit. If the protection circuit activates,

immediately disconnect the unit from the power source and

allow it to cool.



Replacing The Fuse:

The fuse is located on the control panel under the black

plastic cover marked "fuse" To determine if a glass tube fuse

has failed remove the fuse and inspect the internal filament.

If the fuse is bad it will have a gap in it, often accompanied

by a burn mark on the inside of the glass. Occasionally,

glass tube fuses can appear to be intact yet still not function.

In such cases, a separation of the filament from the metal

end renders the glass tube fuse inoperable.

Glass tube fuses have the amperage of the fuse stamped on

one of the metal ends. Be sure to replace it with the same

rated fuse to be certain the proper circuit integrity is

maintained.

Warranty

This portable High Volume Air Compressor is warranted by

Q Industries, Inc., to be free of defects in materials and

workmanship for a period of 2 years from date of original

purchase. This warranty does not cover units damaged by

abuse or operated above recommended pressures. There is

no other warranty, hereunder, either expressed or implied.

In the event of a defect, the air compressor will be repaired

or replaced at our option. Please contact Q Industries, Inc.

by email or telephone to obtain a return authorization

number and a shipping address. Q Industries, Inc. shall not

be responsible for any other incidental, contingent, or

consequential charges or damages. This warranty gives you

specific legal rights, and you may also have other rights

which vary from State to State. Some States do not allow

limitations on how long an implied warranty lasts or the

above limitations or exclusions may not apply to you.

Printed in China

The style, shape and overall appearance of this product and

its packaging are used by Q Industries Inc. pursuant to a

license.

"Cholesterol and gluten free and we do not test on animals. "