AmeriWater SCALA2 Руководство по эксплуатации и техническому обслуживанию - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Водяной насос AmeriWater SCALA2. AmeriWater SCALA2 14 страниц. Booster pump
Печатать страницу
INSTALLATION & START-UP
3
INSTALLATION & START-UP
WARNING:
The installation and operation should be in accordance with local regulations and accepted
codes of good practice.
1. Always mount the pump on the base plate with horizontal suction and discharge ports.
2. Place the pump system on solid, level foundation and secure with screws through the holes in the
base plate. Do not start the pump until it has been filled with water.
3. Unscrew the priming plug and pour minimum 0.5 gallons of water into the pump housing.
4. Screw the priming plug on again.
CAUTION:
Always tighten priming and drain plugs by hand.
5. Connect the 1 ¼" hose barb (inlet) to a water source and the 1" hose barb (outlet) to the water
system with a hose and hose clamps.
6. Open a tap or sample port to prepare the pump for venting.
7. Connect the mains supply cable of the pump to the electricity supply. When the cable is
connected, the Grundfos Eye should illuminate and the pump will start.
8. When water flows without air, close the tap or sample port.
9. Open the highest tapping point in the installation.
10. Adjust the pressure setpoint to the required pressure by means of the UP/DOWN buttons.
11. Close the tapping point. Startup has been completed
4
SCALA2 BOOSTER PUMP
98-2039 Rev A