AmpliVox SB8001 Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Акустическая система AmpliVox SB8001. AmpliVox SB8001 8 страниц. With bluetooth battery powered pa system
Печатать страницу
AUDIO FUNCTIONS
3 MASTER AUDIO CONTROLS:
VOLUME:
This is the master volume control for the system.
BASS:
This control cuts or boosts the bass level.
TREBLE:
This control cuts or boosts the treble level.
MICROPHONE / VOICE PRIORITY SWITCH:
"ON" this feature allows a voice message to take precedence over
the musical program, without turning the music off completely. Full
volume is returned when speaking is complete.
LINE IN INPUTS:
Add pre-recorded music to your presenta-
tions from an external source such as a computer or MP3 player
can be used by connecting to the L/R RCA jacks. A separate
LINE IN VOLUME CONTROL is also provided for controlling
sound level of the external source.
WIRED MICROPHONE INPUT:
jack (this jack will accept either type microphone).
WIRED MICROPHONE VOLUME CONTROL:
just sound level of the plugged-in microphone.
16 CHANNEL UHF WIRELESS MICROPHONE
WIRELESS RECEIVER PANEL
•
Channel Display (A)
•
RF - Radio Frequency Indicator (B)
•
AF - Audio Frequency Indicator (C)
•
ASC / IR Auto Channel Select (Handheld Only) (D)
•
Select Buttons - Manual Channel Selection (E)
•
Mute Level Adjustment (F)
•
Volume Control (G)
RECEIVER / TRANSMITTER SETUP:
• The receiver has its own POWER / VOLUME Control (G). Turn Power
On. A Frequency Channel will appear in the Channel Display (A). Press
Select Buttons (E) to select a channel. Channel number must match
channel number on wireless transmitter.
• MUTE LEVEL (F) is set at half way mark when it leaves the
factory. If speaker sound is breaking up, turn level clockwise with small
screwdriver until condition improves.
•
The transmitter bodypack (IF USED) is operated by 1 - "AA" 1.5 Volt
alkaline battery. Slide off battery cover (H) and install battery as shown.
Make certain the battery is fully seated in its compartment so the cover
slides in place easily. Battery life with alkaline batteries is approximately
8 hours of operating time.
•
Select a channel (1-16) on side panel (I) using the supplied screw driver
to select channel number. Channel selected should match channel on
receiver. When transmitter and receiver are set to correct channel the
RF indicator (B) will glow red when transmitter is turned on.
•
Plug the Lapel microphone into the Mic Input Jack (K). The microphone
can be clipped to a necktie or other clothing, using the supplied clip. The
lapel mic should be placed under the chin, as close to the center of the
body as possible.
•
Slide the power ON/OFF switch (J) to the ON position (the LED indicator
light will illuminate green). Replace batteries when this LED turns red.
When turned
One combination XLR / ¼"
Use to ad-
TONE CONTROL:
Use to adjust sound of plugged-in mi-
crophone.
ECHO CONTROL:
This is a sound effect feature that
makes the audio signal sound as though it's in a large area,
such as a large cathedral or a cave, by repeating the sounds
that come into the SW800 through the microphones or any of
the accessories. The listener will hear the original sound, plus
the repeated sounds created by this feature.
INPUT/OUTPUT XLR JACKS:
speaker using XLR type cable. XLR Output can also be used
to connect to other electronic devices.
LINE SET:
When using the SW800 as an extension speaker
you need to select one speaker as the "MASTER" and other
speaker/s as "SLAVE". Slide switch to the designated posi-
tion. The speaker chosen as the "MASTER" becomes the
main control for all inputs.
SLAVE INPUT CONTROL:
used as a SLAVE speaker.
A
E
Wireless Transmitter - Bodypack
Battery
Cover
H
5
Connect only powered
Use to adjust input level when
D
B C
G
F
Top Panel
J
K
Channel
Selector
I