Andersen Verilock 0113696 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Датчики безопасности Andersen Verilock 0113696. Andersen Verilock 0113696 16 страниц. For a-series and 400 series windows and patio doors, 200 series patio doors and renewal by andersen windows
Battery Replacement Instructions - continued
400 Series & A-Series Casement and Awning Windows
1. Move the window lock handle to the center
position. The sash can be open or closed.
2. Remove the lock handle with magnet.
3. Remove the VeriLock sensor assembly using a small
thin blade putty knife, taking care not to scratch the
wood or VeriLock sensor assembly (VeriLock sensor
assembly is located on the left-hand lock for awning
windows - as viewed from the interior). Remove the
VeriLock sensor assembly straight backwards being
careful not to damage the sensor.
4. Carefully remove the battery cap.
5. Remove discharged battery from the VeriLock
sensor assembly using a small flat blade
screwdriver to carefully pry the battery from the
terminal. (see battery disposal information on
page 5).
6. Replace the battery with (1) one fresh CR-2025
lithium coin cell battery with the positive (+) side
facing out as shown.
7. Reapply the battery cap.
8. Reinstall the VeriLock sensor assembly making
sure the arrow on the face of the sensor is pointing
upward. Continue to fully push the assembly in. The
assembly will snap into place around the lock when
properly inserted.
8. Reinstall lock handle with magnet onto lock lever by
pushing handle onto lock until an audible snap can
be heard.
9. Verify the proper battery polarity by observing the
L.E.D. light illumination during the lock operation.
If the L.E.D. does not illuminate, check to make
sure Steps 6 - 8 were followed correctly and check
to make sure the magnet is positioned properly
around the lock handle as shown.
10. Close and lock the window unit.
11. Verify that the sensor is communicating with your
security system or self-monitoring application
by unlocking the window and checking for the
unlocked message and then open the window and
checking for the window open message.
9142268
400 Series & A-Series
Casement and Awning Windows
(Interior View)
NOTE: VeriLock sensor assembly is
installed on the left lock on awning units,
as viewed from the interior.
Battery
Cap
CR-2025
Battery
Wider edge of VeriLock
sensor assembly toward
side jamb.
Trim Stop
Pry trim stop gently with
putty knife while inserting
VeriLock sensor assembly.
6
User's Guide
Lock
VeriLock
Lever
Sensor
Assembly
Lock
Handle
Lock
Handle
Magnet
Small Flat Blade
Screwdriver
VeriLock
Sensor
Assembly
Insert screwdriver
into slot end to
remove battery.