Andis UltraEdge AGC2 Руководство по эксплуатации и уходу - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Машинка для стрижки волос Andis UltraEdge AGC2. Andis UltraEdge AGC2 20 страниц. Andis company model agc2 hair clippers - use and care guide
Также для Andis UltraEdge AGC2: Руководство пользователя (2 страниц), Технические характеристики (2 страниц), Технические характеристики (2 страниц), Список деталей (1 страниц), Использование и уход (2 страниц)

8. Do not use this appliance with a damaged or broken blade or

comb, as injury to the skin may occur.

9. To disconnect turn control to "off" then remove plug from outlet.

10. wArNING: During use, do not place or leave appliance where it

may be (1) damaged by an animal or (2) exposed to the weather.

SAvE tHESE INStruCtIoNS

tHIS produCt INtENdEd for profESSIoNAL uSE

To reduce the risk of electric shock, this appliance has a polarized plug (one

blade is wider than the other). This plug will fit in a polarized outlet only one

way. If the plug does not fit fully in the outlet, reverse the plug. If it still does

not fit, contact a qualified electrician to install the proper outlet. Do not change

the plug in any way.

opErAtING INStruCtIoNS

Please read the following instructions before using your new Andis clipper. Give

it the care that a fine precision built instrument deserves and it will give you

years of service. Plug cord into electrical outlet, operate 120 volt, 60 cycle AC

electrical current or as noted on unit.

Your Andis clipper comes with normal and high speed operation (Diagram A).

Use the normal setting (setting #1) for most cutting needs. Use the high speed

setting (setting #2) for cutting through heavy hair. To start clipper move switch

button by pressing down on the lock mechanism and moving to the #1 or #2

position. To stop, press down on the lock mechanism and move switch button

back to original position. After using your Andis clipper, rewrap cord, and store

in a safe place.

To remove blade set, first make sure your clipper motor is switched "OFF". Push

blade release mechanism under blade hinge (Diagram B). While holding down

the blade release mechanism, push down on blade, then gently pull the blade

forward (Diagram C), and slide it off the blade hinge. If your blade hinge should

snap closed and is flush with the clipper, use a small standard screwdriver to

pry the tongue of the hinge out (Diagram D). NotE: Hair may accumulate in the

front cavity of the housing under the blade. If this happens, you can clean out

the hair by brushing out the cavity with a small brush or an old toothbrush while

the blade is off the clipper (See Diagram E for location of cavity being referenced).