Electrolux EFA9620 Руководство пользователя - Страница 15

Просмотреть онлайн или скачать pdf Руководство пользователя для Вентиляционная вытяжка Electrolux EFA9620. Electrolux EFA9620 18 страниц.

Печатать страницу

Replacing the Charcoal Filter

This ﬁ lter cannot be washed or regene-

rated, and must be replaced when the F

touch control starts to ﬂ ash, or at least

once every 4 months. The alarm is only

triggered when the motor is on.

Enabling/Disabling the alarm signal

• In Recirculation Version Hoods, the

Filter saturation Alarm must be ena-

bled at the time of installation or later.

• Switch off the lights and the motor.

• Disconnect the mains power supply

to the hood by removing the motor

unit power supply cable connector,

switching off the power supply at the

Mains or turning the Main switch off.

• Restore the connection, pressing and

holding T2.

• Release the touch control, touch

controls L, T2 and F will light up nor-

mally.

• Within 3 seconds press the touch

control F until the key itself ﬂ ashes to

conﬁ rm as follows:

• 2 ﬂ ashes – Charcoal Filter saturation

Alarm ENABLED

• 1 ﬂ ash - Charcoal Filter saturation

Alarm DISABLED

Maintenance

Reset the alarm signal

• Stop the motor.

• Press the touch control F for at least

4 seconds, until the touch control T1

ﬂ ashes.

Replace the Filter

• Pull the Comfort Panel to open it.

• Remove the metal grease ﬁ lters.

• Remove the saturated charcoal ﬁ lter,

turning the fasteners provided.

• Fit the new ﬁ lter and fasten it its cor-

rect position.

• Put the metal grease ﬁ lters in their

seats.

• Close the comfort panel.

Light replacement

20 W halogen light.

• Remove the snap-on lamp cover by

levering it from under the metal ring,

supporting it with one hand.

• Remove the halogen lamp from the

lamp holder by pulling gently.

• Replace the lamp with a new one of

the same type, making sure that you

insert the two pins properly into the

housings on the lamp holder.

• Replace the snap-on lamp cover.

electrolux 15