Advanced Native Technologies ING 20 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Микрофон Advanced Native Technologies ING 20. Advanced Native Technologies ING 20 15 страниц. Ing series uhf in ear monitor systems sistemi in ear monitor uhf
Печатать страницу3 "AF LEVEL" AF 1 & AF2 INPuT LEVELS (ING 20T only)
These controls allows you to adjust the signal levels of inputs AF1 e AF2.
4 ANTENNA SOCKET
Connect the supplied antenna to this BNC socket.
5 PAD (ING 30T only)
This selector allows to reduce the input signal by 12dB.
6 MONO/STEREO (ING 20T only)
This selector allows to choose between Mono or Stereo listening. In the latter case
the signals of AF1 and AF2 inputs are independent, while in the mono mode both
earphones have the same signal (s).
8
5
6
8
ING 20R
1
2
3
4
9
2.2 | ING 20R/ING 30R BELTPACK RECEIVER
1 VOLuME CONTROL WITH POWER SWITCH
To turn on the receiver, turn the knob to the right until you hear a click, to turn it off
completely rotated to the left until it clicks.
Turn the knob to the right to increase the volume, and to the left to decrease it.
CAuTION: High listening volume may permanently damage your hearing.
2 RF/LOW BATT LED
With correct reception this indicator is lit green, it blinks red when the battery is low.
3 PHONES
3.5mm stereo mini-jack connector for earphones/headphones.
ING Series
6
User manual |
Series
7
5
8
6
ING 30R
1
2
3
4
9
4 FIXED ANTENNA
For signal receiving.
5 LCD
The display shows the levels of audio, signal reception, and battery charge,
numeric data for GROUP and CHANNEL and the lock. The STEREO mode
indicator is active only when this mode is selected in the transmitter.
ING 30R receiver has also status indicators of TONE, LIMITER and MIX
functions, which are described later.
6 SET
Press this button to select functions, and to set receiver parameters
values.
7 ESC
(ING 30R only)
Press this button to return to the main menu.
8 uP/DOWN
Use these buttons to select higher or lower values/
functions for each parameter.
9 BATTERY COMPARTMENT
To replace the batteries, lightly press on the sides of
the compartment cover and lift forward.
Take out the discharged batteries, and insert two new
batteries (respecting the figure in the compartment)
then close the lid. Remove the batteries from the receiver
when not in use for extended periods.
WEARING THE BELTPACK RECEIVER:
Clip the receiver to a belt or to the shoulder strap of your guitar. For better
fastening reliability it's preferable to secure it as shown in the figure, then
fasten it in a way that the belt is tight from the clip.
ING Series
7
| User manual