Alert 750R Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Дистанционное пусковое устройство Alert 750R. Alert 750R 15 страниц. Remote engine starter with alarm system

Печатать страницу

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your

transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm

function and remote start functions are bypassed, however the remote panic feature and remote door

locks will remain operational. To use the valet mode, the system must first be disarmed either by using

you remote transmitter, or by operating the Manual override sequence.

Enter Valet Mode:

1. From the disarmed condition, turn the ignition to "ON" position.

2. Push and hold valet switch for 2 seconds until the

LED turns on. The LED wills remain on as long as the

system is in 'valet mode'.

Exit Valet Mode:

1. Return to normal operation, turn ignition 'on'.

2. Push and hold valet switch for 2 seconds, The LED

wills turns off indicate the system are exiting the valet

mode.

REMOTE VALET: (System in Disarm or Valet mode)

Press and release

A parking flash to confirm enters valet mode and two parking lights flashing to confirm exit valet mode.

L. CAR LOCATOR

Under armed mode, press the

chirp 6 times. The parking light will flash 12 times, for you to easily locate your car.

M. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.

1. Press and hold

2. During panic mode, the normal function of this transmitter button will be suspended.

The

and

buttons can be used to lock and unlock the doors (if the option is

installed), however once the

(where installed) will be enable allowing the vehicle to start.

3. To stop the alarm, press and hold

seconds. Also if any transmitter buttons other than

released, the panic mode will be turned off immediately.

4. If the button is not pressed, the alarm will automatically stop after 30 seconds.

N. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

1. Light impact will trigger the warn-away signal.

2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the

programmed sequence.

The starter disable relay (if installed) prevents the vehicle's starter from cranking. The siren, horn, parking

lights, and dome light will turn on to alerting of an intrusion for 30 seconds. Then it will stop and automatic

reset and re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of

6 times of 30 seconds cycles.

Trunk/Hood

Trigge

750R OP

button on the transmitter three times within 3 seconds to enter / exit valet mode.

button to active car locator function. The siren will

(See Alarm Feature I

button for 3 second. The alarm will immediately sound.

button is pressed, the vehicle's starter disable device,

Shock Sensor

Doors Trigger

Trigger

Remote Door Lock

7 Programming)

button on the transmitter again for 3

button is pressed and

Ignition

Trigger

MAY/03/2004

Remote Door Unlock

Warn-away

Trigger