Bose Acoustimass 3 Series Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Динамики Bose Acoustimass 3 Series. Bose Acoustimass 3 Series 42 страницы. Powered speaker system
Также для Bose Acoustimass 3 Series: Руководство пользователя (17 страниц), Руководство пользователя (10 страниц), Руководство (43 страниц)

A non-serviceable thermal fuse is located inside the transformer to limit the maximum

temperature to 145 °C under abnormal conditions. However, in most cases the external fuse

(F1) should fail before the internal transformer thermal fuse. The thermal fuse can be checked

by measuring the continuity between pins 1 and 4 (black and white wire) of the primary

connector. This connector is located on the Equalizer PCB.

2. Differential Input Stage

Audio input applied at the phono jack (J8) connects directly to the right (left) differential amplifier

buffer. This stage accomplishes several functions:

- Provides rejection of common-mode interference (such as hum) that might be picked up

by the long audio cable between the AM-3P and lifestyle music center

- Provides input overload and ESD protection through diodes (D101-104)

- Removes radio frequency Interference through C103,125,127

- Provides DC blockage by C101,102

- Provides a 6 dB gain through op-amp U101.

3. Compressor/Treble Stage

U102 (pins 1,2,3), with potentiometer VR2 at the center position, operates as a conventional

inverting operational amplifier stage with a gain of 6 dB. However, when voltage overload is

present at the speaker outputs, transistor array U1 (pins 1,2,3) receives a turn-on signal from

the compressor detect stage. Under this condition, the transistor acts as a variable resistor

to ground, and with R107, forms a resistor divider network that attenuates the audio signal.

The amount of attenuation and timing action is carefully controlled by the compressor detect

stage (to be discussed later).

Potentiometer VR2 adjusts the amount of treble boost or cut. In the full counterclockwise

position, the wiper (pin 4) shorts to pin 1. The maximum boost and cut frequency response

graph is shown in Figure 2 on page 4.

4. High Frequency (HF) Equalization

High frequency equalization and crossover is achieved through three cascaded active EQ

stages. These stages consist of U103,U104 and U105. The purpose of equalization is two-

fold:

- It provides very sharp low frequency attenuation below 200 Hz (the crossover frequency)

to prevent overload of the L/R speakers

- It provides finely tailored correction in the speaker pass-band so that overall frequency

response of the system is acoustically correct.