advanced scale models Pitts Special Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка advanced scale models Pitts Special. advanced scale models Pitts Special 10 страниц.

Печатать страницу

THE WINGS

STEP 1.

Glue each of the aileron hinges (four per aileron) half

way into the wing training edges using thin cyano

ensuring the glue soaks into the hinge and the

surrounding wood.

STEP 2.

Fit teh ailerons to the wings ensuring gap-free hinge

lines, making sure the ailerons are centred between the

root and tip, and that each is free to move through their

entire travel. Carefully add a couple of drops of thin

cyano to each hinge ensuring that the glue does not run

through the hinge line onto the bottom of the wing. Turn

the wing over and drop more cyano onto each hinge

from the other side. Repeat for both wings.

STEP 3.

Check the fit of your choice of aileron servos into the

pre-cut apertures in the underside of the lower wing.

Connect extension leads to the servos as necessary. Fit

the rubber grommets and brass ferrules supplied with

your servos, pilot drill then mount your servos as shown

using the screws supplied with your radio.

STEP 4.

Locate the aileron horns, pushrods and nylon clevises

and make up the linkages as shown. Position each horn

on its aileron - in line with the aileron pushrod and the

hinge line - then pilot drill the ailerons and mount the

horns with the screws and horn backing plates

supplied.

STEP 5.

Locate the aileron connection horns, pushrods and

nylon clevises that will link the upper and lower ailerons.

Align the horns on the hinge lines as shown so that

each pushrod passes through the pre-cut holes in the

lower wing. Pilot drill the ailerons and mount the horns

with the screws and horn backing plates supplied.

_____ Page 3 _____