AirTest TR9299 Регулировка

Просмотреть онлайн или скачать pdf Регулировка для Передатчик AirTest TR9299. AirTest TR9299 2 страницы. Co2 and temperature sensor transmitter

AirTest-WiFi Transmitters: Setting Audible And Visual Alarm

Visual And Audio Alarm Function Adjustment

It is possible to have the TR9299 or other AirTest WiFi transmitters provide an audible beep and flash an on-

board LED light if CO

levels exceed a targeted concentration. This operating mode is possible in all installation

possibilities of the sensor including stand alone, connected to a network, or logging to a web portal.

What is Needed

In addition to the TR9299-Wifi sensor you will need the free PointView PC Interface Software and the CB9999

USB cable interface designed to work with AirTest wifi products. The cable can be purchased separately from

AirTest. Once you have the cable and software it can be reused for future installations and adjustments. The

software also allows configuration of the sensor to connect to WIFi networks, gateways and web portals.

The PointView Software can be downloaded here: (www.airtest.com/support/sw/PointViewSensorUtilitySetup.zip)

Instructions

Prior to making any adjustments to the sensor it is recommend that an ambient air

calibration be performed as documented in the AirTest Wifi Manual

www.Airtest.com/man/AirTestWifiman.pdf.

Connect the CB9999 cable into the top of the sensor and plug into a PC USB port that has

the PointView software installed. The red LED light on the front of the TR9299 should be

activated.

When you first open the PointView software and connect a sensor, a Connection Wizard

may appear. This is used to connect the sensor to our remote monitoring web portal

(Additional monitoring fees involved). To be able to adjust the sensor, press the "Exit"

button. Then select "No" to exit the wizard application and enter the Utility mode that allows

customized adjustment of the transmitter.

Open the PointView Software and press the "Retrieve"

button on the right side of the window. This loads the

current settings for the Transmitter. A blue progress

bar should appear at the bottom of the window as

data is loaded from the sensor. Once all settings

have been loaded a dialog box will appear that says

"Sensor parameters retrieved". Press "OK".

Go to the Sensor Tab.

Set Transmit Period to 12 hours. This minimizes

•

WiFi broadcasts and saves battery life. Should be

set this way if you are not using the Wifi. If you

are using the WiFi 10 minutes is appropriate.

Set Tries to 1. Again this minimizes battery use.

•

Select the shortest logging period (2 min). This

•

sets the sensor to wake up every 2 minutes to

take a measurement.

Audible & Visual Alarm Settings for AirTest WiFi Products

Page 1 of 2