DSC PC1150 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Датчики безопасности DSC PC1150. DSC PC1150 13 страниц. Tyco security system instruction manual
Disarming the System
Enter the premises only through the door(s) designated by your installer as the Exit-Entry door. Entering
by any other door will sound an immediate alarm. As soon as the entry door is opened, the keypad
sounder will come on to indicate that the system should be disarmed. Go to the keypad and enter your
Access Code. If an error is made entering the code, press the [#] key and enter your code again. As
soon as the correct code is entered, the "Armed" light will go out and the keypad sounder will silence.
The correct Access Code must be entered before the entry time expires. The entry time delay may be
changed by your installer.
If an alarm occurred during the period the system was armed, the "System" light and the Zone Light of
the zone that caused the alarm will flash for two minutes. After the two minute period, the "System" light
and Zone Light will stop flashing and the system will return to the ready state. Pressing the [#] key during
the two minute period will cancel the alarm memory display.
If a trouble is present when the system is disarmed, the "System" light will come ON (See Viewing Trouble
Conditions section to determine the source of the trouble). Note that troubles will not display while the
system is in the Alarm Memory Display Mode.
If you return home and find that an alarm has occurred while you were away, it is possible that an intruder
may still be on the premises. Go to a neighbour's house, and call the local police to investigate.
Quick Arm Feature
Your Installer will inform you of whether or not that Quick-Arm feature is enabled on your system. When
the Quick-Arm feature is enabled, the system may be armed simply by pressing [ ][0] instead of a 4 digit
Access Code. This feature allows a person to arm but not disarm the system.
Press [#] to return to "Ready".
Door Chime Feature
The door chime feature is used, while the system is disarmed, to provide a tone from the keypad each
time a door or window is opened or closed. The doors and windows which will provide this indication are
programmed by your installer.
Enter [ ][6][Master Code][6] to turn the door chime feature ON and OFF. When the command is entered,
the keypad buzzer will beep 3 times if the door chime feature is being enabled, and will sound one long
beep if it is being disabled.
Press [#] to return to "Ready".
Alarm Test
Enter [ ][6][Master Code][8] for a 2-second test of the keypad lights, keypad buzzer, battery and the
siren.
Press [#] to return to "Ready".
4