AIRTRONICS SD-10G Aero Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Игрушка AIRTRONICS SD-10G Aero. AIRTRONICS SD-10G Aero 16 страниц. 2.4ghz fhss-3 radio control system
Также для AIRTRONICS SD-10G Aero: Руководство по быстрой настройке (8 страниц), Краткое руководство по эксплуатации (5 страниц)

Печатать страницу

TROUBLESHOOTING GUIDE

PROBLEM

Inadequate transmitting range

Servo will not move to the end of its range

Safety Link system not functioning

Cannot copy programming data

Cannot copy Flight Mode programming data

Custom menu display empty

PACK NOT READY!! message displayed

when Initializing Memory Expansion Card

Cannot change Surface menu Adjustment

Values

Control linkages bind when using the available

pre-programmed mixes or a C-Mix

Servo moves too much, or doesn't move

enough, when trim switch is moved

Drastic control changes when switching

between Flight Modes

One or more mixes do not function

Control surface trim changes when switching

between Flight Modes

Transmitter/receiver range check fails

Camber trim changes when you change

camber percentage value

CAUSE

Battery not fully charged

Antenna retracted

Receiver antennas not mounted

correctly in your model

Transmitter in Low Power mode

T r a n s m i t t e r o p e r a t i n g i n

Trainer>Slave mode

Servo Limit Adjustment Value

set too low

Safety Link number does not

match Model Memory number

Using FHSS-1 receiver

Attempting to copy programming

data to the same model memory

number

Attempting to copy Flight Mode

programming data to the same

Flight Mode number

No shortcuts added to Custom

Memory Expansion Card not

installed

Adjustment Options Lock is

engaged

Mixes can cause servos to move

beyond the programmed EPA

Adjustment Values

Trim Step resolution requires

adjustment to suit your preference

Flight Mode Delay function not

utilized

Mixes not assigned to switch

Trim set to SEP in Trim Flight

Mode menu

Low transmitter and/or receiver

batteries

Receiver antennas not mounted

correctly in your model

Aircraft sitting in tall grass

(usually sailplanes only)

Camber Point is incorrect

Page 194

SOLUTION

Fully charge battery

Extend antenna and hold the transmitter so

that the antenna is 90º to the ground

Mount receiver antennas as described

Inhibit Low Power mode to operate in Normal

mode

Inhibit the Trainer function to use transmitter

normally

Adjust servo Limit Adjustment Value in the

surface menu

Change Safety Link number to match Model

Memory number of current model

Use FHSS-3 receiver. Safety Link is compatible

only with FHSS-3 receivers.

Copy programming data to a different model

memory number

Copy Flight Mode programming data to a

different Flight Mode number

Add shortcuts to your favorite menus by

highlighting the desired menu, then pressing

the YES/+ key

Install Memory Expansion Card and make sure

it's fully seated into position

Inhibit Adjustment Options Lock

Use the Limits function in the Surface menu to

set the maximum allowable travel of your servo

Adjust Trim Step resolution to suit your

preference

Program Flight Mode Delays to smooth the

transition of servo movement when switching

between Flight Modes

Assign mixes to a switch (or switches).

Set Trim to COM in Trim Flight Mode menu

Fully charge transmitter and receiver batteries

Mount receiver antennas as described

Lift model out of grass for range check

With the Camber Preset percentage value set

to 0%, Auxiliary Lever (VR6) must be centered.

With the percentage value set to 100%, the

bottom of Auxiliary Lever (VR6) must be

pushed all the way forward. With the percentage

value set to -100%, the bottom of Auxiliary

Lever (VR6) must be pulled all the way back