Anywire ASLINK BL296SB-04FS-4A-20 Руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сенсорные терминалы Anywire ASLINK BL296SB-04FS-4A-20. Anywire ASLINK BL296SB-04FS-4A-20 15 страниц.
Печатать страницу[Data Configuration]
BL296SB-04F-4A-20, BL296SB-04FS-4A-20
Address
n+3
n+2
offset
IN3
Bit input
BL296PB-04F-4A-20, BL296PB-04FS-4A-20
Address
n+3
n+2
offset
Bit output
OUT3
OUT2
BL296XB-04F-4A-20, BL296XB-04FS-4A-20
Address
n+1
offset
IN1
Bit input
OUT1
OUT0
Bit output
■Status details
The contents of an alarm detected with this unit can be checked with the "status detail area
on the master unit.
A bit corresponding to the status detail area turns ON depending on the contents of the alarm.
Status detail area of the master unit
Status
b15
details
b0: Slave unit voltage drop (DP-DN-side voltage drop)
b5: I/O power supply drop (24V-0V-side voltage drop)
*
1 This can be used on the master unit having the status detail area. For details, refer to the manual for the master unit.
[Monitor Display]
LED name
Display status
Lit
LINK
Flashing
(Green)
Unlit
Lit
ALM
Flashing
(Red)
Unlit
Alternate ashing
LINK
LINK
ALM
ALM
LINK
LINK
ALM
ALM
Lit
I/O
(Orange)
Unlit
*
2 This indication appears when the use of the single unit simpli ed replacement function fails.
(This operation occurs on the S/W version "B" or later version.)
*
3 If ID duplication is detected when the master unit executes automatic address recognition,
this indication appears.
*
4 For S/W version "B" or later version: This indication appears when transmission signal and
power supply are normally connected, and the unit is set to the factory-set address.
For S/W version "A" or 3-digit lot No.: This condition is detected when the master unit
executes automatic address recognition.
n+1
n
*
n = Bit address number assigned to this unit
IN2
IN1
IN0
n+1
n
OUT1
OUT0
n
IN0
b14
b13
b12
b11
Description
Transmission signal error
Model mismatching error *
Transmission signal received
No transmission signal (disconnection and
reverse connection of DP and DN lines included)
I/O power supply drop
Slave unit voltage drop
Model mismatching error *
No ALM available
ID duplicated *
or ID unregistered *
3
Model mismatching error *
ON
OFF
-BL296*B04F*4A20 10/15-
b10
b9
b8
b7
2
2
4
2
*
1
"
b6
b5
b4
b3
LED indicators
If an error is indicated, identify a cause of the error
by checking lit/ ashing status with the table on the
left, and eliminate the cause of the error.
Once the cause of the error is eliminated, the error
indication will be automatically reset.
b2
b1
b0
LINK
ALM
I/O 0
I/O 1
I/O 2
I/O 3