DANLERS HASE 12RF Указания по установке - Страница 2

Просмотреть онлайн или скачать pdf Указания по установке для Пульт дистанционного управления DANLERS HASE 12RF. DANLERS HASE 12RF 2 страницы. Radio remote control hand senders

Печатать страницу

Hand Sender operation

With the HASE 12RF one of the

6 pre-selector buttons must be

pressed before either of the up

or down buttons are pressed,

the presses are confirmed by

a green LED.

The HASE 12RF remembers

the last pre-selector number

used, so if the same pair of

channels is required again the

pre-selector does not have to

be pressed again.

The HASE 2RF includes a red

confirmation LED.

Please note the confirmation

LEDs just confirm that the

command was sent, not that

it was received.

HASE 12RF

Short press to switch on, long press to

dim up. Channels 1 to 6 use left button.

Channels 7 to 12 use left button.

Green

Confirmation

LED

6 Pre-

selector

buttons

Short press to switch off, long press to

dim down. Channels 1 to 6 use left button.

Channels 7 to 12 use left button.

HASE 2RF

HASE 1RF

Short press to

switch on, long

press to dim up.

Short press to

switch off, long

press to dim

down.

Changing batteries

The batteries in the hand senders should last approximately five

years, since they are only used when a command is sent (this can

be severely reduced if the sender buttons are accidentally held down

down). If the transmission range of the hand sender starts to reduce

it is quite a simple process to change the batteries.

HASE 12RF:

• Remove the back cover and replace the two AAA cells.

HASE 2RF:

• Unscrew the back plate, remove the outer frame and lever off the

rocker cover using a screwdriver to reveal the battery. Remove

the battery retaining clip and replace the CR2430 battery with the

positive terminal facing up. Reassemble in reverse order.

HASE 1RF:

• Remove the two screws from the

back of the casing, keep the casing

closed and turn it over, with the blue

buttons on top remove the top half

of the casing. Do not remove the two

brass eyelets which are part of the

push button mechanism. Remove

the battery retaining clip and replace

the CR2430 battery with the positive

terminal facing up. Reassemble in

reverse order, ensuring brass eyelets

Preprogrammed receivers

If, by special request, any receivers have been factory preprogrammed

to any particular hand senders, do not try to program the receivers to

any hand senders yourself. Please just follow the instructions on how

to install a receiver, along with any additional instructions.

If you wish the hand sender to control any EXTRA receivers then they

can be user programmed by following the programming procedure

included in the installation notes of the receiver.

Brass

eyelets

in correct

position