Audionet Amp I V2 Руководство пользователя - Страница 13
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Audionet Amp I V2. Audionet Amp I V2 18 страниц. Stereo audio power amplifier
Печатать страницу
6
Operating
6.1 Powering up
First of all, please make sure your AMP1 V2 is connected correctly to
your pre-amplifier, speakers and mains (see section 'Installation and
power supply' on page 8 and section 'Inputs and outputs' on page 10).
The AMP1 V2 is a stand-by unit. As soon as the amplifier is connected to
the mains, the unit is in stand-by mode
Only in cases of extended absence (like vacations) or if massive trouble
on the mains power is to be expected it is recommended to disconnect the
AMP1 V2 from mains.
Important
·
Never pull the mains cord while the AMP1 V2 is switched on!
Before you pull the mains plug, power down the unit to stand-by
mode first.
6.2 Switching on/off
To power up the AMP1 V2 from stand-by mode, press the power key on
the front panel. Now the AMP1 V2 is in normal operating mode.
If you would like to switch off the unit, please press the power key on the
front panel.
Note
·
If 'remote controlling' via Audionet-link is used, after switching off
the AMP1 V2 is always in stand-by operation with low power con-
sumption. Only in case of longer absence the AMP1 V2 should be
disconnected from the power supply (mains unplugged).
6.3 Using Audionet Link
If your AMP1 V2 is connected to an Audionet pre amplifier via Audionet
Link, use the remote control of the pre amplifier to automatically switch
on/off the AMP1 V2 (and all other Audionet units also connected via
Audionet Link).
For setting up the necessary connections please refer to section 'Audionet
Link' on page 12.
13