Aussie Traveller SUNBURST ECLIPSE Краткое руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Аксессуары Aussie Traveller SUNBURST ECLIPSE. Aussie Traveller SUNBURST ECLIPSE 5 страниц.
Печатать страницуROLL UP PROCEDURE
1. Lower both right and left support arms to the
dome nut position using the lift handle and trigger.
Lower one end 50% then the other fully and then
the first one fully.
2. Loosen knob on rafter. Lower rafter by depressing
lever on the outside of the frameset leg which
will allow the slider to be released. Slide rafter to
bottom of support arm. Repeat on other arm.
3. Slide pull strap to the right until ratchet lever is
within reach.
4. Grasp pull strap, and by pulling out, release the
pressure on the ratchet lever. Locate ratchet lever
behind roller and rotate lever upwards and forward
towards the front of the awning.
If ratchet lever is difficult to operate, use pull strap
to rotate roller slightly as if to slacken fabric further.
This reduces tension on mechanism and lever.
1300 663 868 | [email protected] | aussietraveller.com.au
BRISBANE SHOWROOM: 11-15 Oasis Court, Clontarf QLD 4019 | MELBOURNE SHOWROOM: 235 Barry Road, Campbellfield VIC 3061
5. Slide pull strap more towards the centre of awning.
Use pull strap to control speed of awning when
rolling back towards R.V.
To avoid creating a bulge in awning fabric allow
strap to roll up diagonally side by side across roller
and fabric.
6. Lock both support arms in travel position. To lock
squeeze rafter and top support arm together rotate
travel locks behind rafters.
7. Tighten black knurl knobs. Ensure roller does
not move when pull strap is given a slight tug.
This confirms the ratchet mechanism is working
correctly.
WARNING: The awning is under tension and can
snap back against the vehicle. To avoid damage
to awning or vehicle, DO NOT release ratchet lever
without holding pull strap.