Aussie Traveller SUNBURST ECLIPSE Краткое руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Аксессуары Aussie Traveller SUNBURST ECLIPSE. Aussie Traveller SUNBURST ECLIPSE 5 страниц.
Печатать страницуGENERAL MAINTENANCE
•
Lubricate control handles, lock buttons, locking
knobs, support arms and rafter sliders with
silicone or similar lubricant to ensure easy
operation.
•
Check correct setting of adjustable stop bolts.
•
Ensure all rivets and screws in brackets are tight.
•
Keep your awnings clean. This is the best
protection against mildew. Although the fabric
is mildew resistant, mildew can still grow on
accumulated dirt and eventually damage or stain
the fabric.
•
Wash down your awning. You can use a mild soap
and water solution, or an approved vinyl cleaner,
brushing lightly with a cloth or soft brush. Rinse
thoroughly and allow drying prior to storage. We
recommend doing this on a hot, sunny day.
•
Keep the underside of your awning clean by
simply brushing with a clean household broom. It
may also be washed in the same manner as the
top.
GENERAL TIPS
•
In light rain conditions, lower one arm 300mm-
600mm to allow water to drain from fabric and
avoid water pooling.
•
Accessories such as Aussie Traveller's Anti Flap
Kit and Curved Roof Rafters will help eliminate
wind flap and water pooling.
•
When adding walls we recommend Aussie
Traveller's Anti Flap Kit with built in wall
attachment system.
•
To avoid excessive force being exerted on
ratchet mechanism do not remove support arm
from bottom bracket until ratchet lever has been
placed in down (roll out) position. Refer to label on
support arm. Return ratchet lever to travel position
when arm is replaced.
1300 663 868 | [email protected] | aussietraveller.com.au
BRISBANE SHOWROOM: 11-15 Oasis Court, Clontarf QLD 4019 | MELBOURNE SHOWROOM: 235 Barry Road, Campbellfield VIC 3061
GENERAL TIPS
•
If the ratchet mechanism is subjected to excessive
force the ratchet lever may become over tensioned
and difficult to operate. To relieve the tension:
In roll up position - Release right support arm from
bottom bracket. Swing arm away from R.V. slightly
until ratchet lever can be moved to open (roll out)
position. Return support arm to bottom bracket.
In rolled out position - Rotate roller slightly, as if
to slacken fabric. Reverse ratchet lever. When
releasing lever maintain your grip on pull strap, to
prevent awning from snapping back against van.
•
Always close the awning in strong winds or rain.
•
Damage to awning fabric, hardware and locking
mechanism caused by wind, water pooling or
extremely high/low temperatures is NOT covered
by warranty. NEVER leave awning rolled out when
unattended.
DO NOT....
•
Do not operate awning in strong winds or rain.
•
Do not allow awning to snap closed excessively
hard.
•
Do not remove support arm from bracket until
ratchet lever has been placed in up (roll in)
position. Refer to previous instructions.
•
Do not overextend awning when rolling out.
•
Do not fold or roll out in extreme cold
temperatures.
•
Do not get insect spray on the vinyl fabric, as
some solutions may cause staining or discolour.
•
Do not allow water to collect on awnings, causing
water pooling.
•
Do not overlook small rips or tears. Have them
repaired or separation will result.
•
Do not wash your awning with truck wash or a
harsh strong solution, or with an abrasive cleaner.
•
Do not BBQ, grill or have campfires underneath
the awning.
•
Do not store awnings when damp, or wet. Mildew
may grow on the surface of a damp awning and
permanently stain the fabric (If it is necessary to
roll the awning away wet then roll out and dry at
the first opportunity).
•
Do not permit leaves, twigs, etc. to remain on your
awning.
•
Do not use a high pressure cleaning jet.