Adedad PL10W Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Adedad PL10W. Adedad PL10W 17 страниц. 20v

removed before carrying out any work on the tool.

Align the belt hook with the mounting hole of the base and tighten the screw. The belt hook can be

installed from the other side according to the operation habit.

The battery pack is not charged when it is purchased. Before using the power tool for the first time, place

the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the

instructions in the battery charger section.

To install the battery pack into the bottom of the handle, align the rails of the battery pack

with the rails in the handle and push the battery into the handle. To connect the battery, slide

the

battery pack fully forward. Until the latch locks into place.

Follow these instructions in order to avoid injury and to reduce the risk of electric shock or

fire:

•

Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.

•

Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on

any part of the power tool.

•

Read, understand, and follow the instructions.

To turn the tool on, squeeze the trigger switch . To turn the tool off, release the trigger switch.

Your tool is equipped with a brake. The anvil will stop when the trigger

switch is fully released. The variable speed switch enables you to select

the best speed for a particular application. The more you squeeze the

trigger, the faster the tool will operate. For maximum tool life, use

variable speed only for starting holes or fasteners.

Continuous use in variable speed range is not recommended. It

may damage the switch and should be avoided.

: Always be sure that the tool is switched off and the battery cartridge is

Trigge

switch

Fig.4