ADEMCO 5800WAVE Руководство по установке и настройке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке и настройке для Система безопасности ADEMCO 5800WAVE. ADEMCO 5800WAVE 4 страницы. Wireless siren module
RECEPTACLE
COVER PLATE
IN POSITION
NOTE:
FOR C-UL INSTALLATIONS THE
MOUNTING SCREW IS NOT USED.
Figure 5. Final Installation
Regular maintenance and inspection (at least annually) by the installer and frequent testing by
the user are vital to continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance
program to the user, as well as acquainting the user with the proper operation and limitations
of the alarm system and its component parts. Recommendations must be included for a specific
program of frequent testing (at least weekly) to insure the system's operation at all times.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following
statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance
with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found
to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user
or installer may find the following booklet prepared by the Federal Communications Commission helpful:
This booklet is available under Stock No. 004-000-00450-7 from the U.S. Government Printing Office, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's
Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
SPECIFICATIONS
Dimensions:
7.5" W x 4.5" H x 2.25" D.
191mm W x 114mm H x 57mm D.
Input Voltage:
120VAC
Current:
205mA. Typical
Range:
200ft (60m) nominal indoors (the actual range to be
determined with the security system in the TEST mode).
Operational Temperature:
32° to 122° Fahrenheit.
MOUNTING
Siren Output Level:
SCREW
95dB at 3 feet
TO THE INSTALLER
FCC ID: CFS8DL5840
"Interference Handbook"
3
C
US
R
LISTED