GREAT PLANES Yard Stik ARF Руководство по эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка GREAT PLANES Yard Stik ARF. GREAT PLANES Yard Stik ARF 16 страниц.

4. Lift the model with your fingertips placed on the tape

lines. If the model is level as shown in the photo the wing is in

the correct position. Proceed to the next step. If the nose of

the model drops, the C.G. is too far forward and the wing will

have to be moved forward. If the tail of the model drops, the

C.G. is too far back and the wing must be moved back. Move

the wing forward or back as necessary by sliding the wing

mounts. Continue to adjust the position of the wing and lift the

model with your fingers on the tape lines until you can get it to

balance. Note: Even though the decals are not on the model

in the photo, they should be on your model at this time.

5. View the model from the rear. Using the stab as an

alignment cue, make sure both wings are at the same angle

when compared to the stab. If necessary, adjust the wing

mounts to get both wings the same.

6. Once you have achieved the correct C.G. and leveled

the wings, use a few drops of thin CA to permanently glue

the wing mounts to the fuselage boom.

CHECKLIST

Before taking your Yard Stik out to the flying field for the first

time (or to your back yard or the park), review the check list

to make sure it is truly ready to fly.

1. Make sure all the controls move in the correct direction.

2. Be sure the control throws match the measurements

provided.

3. Make sure the elevator and rudder are centered by

adjusting the V-bends in the pushrods.

4. Make sure the model balances at the recommended C.G.

5. Check the servo arms to make sure the servo arm

screws are installed.

6. Make sure the pushrod retainers are on the back of the

pushrods on the control horns.

Identify Your Model

No matter if you fly at an AMA sanctioned R/C club site or if

you fly somewhere on your own, you should always have

your name, address, telephone number and AMA number

on or inside your model. It is required at all AMA R/C club

flying sites and AMA sanctioned flying events. Fill out the

identification tag on the decal sheet and place it on the

bottom of the wing.