ADEMCO Honeywell 5806 W3 Руководство по устранению неполадок - Страница 2
Просмотреть онлайн или скачать pdf Руководство по устранению неполадок для Датчики безопасности ADEMCO Honeywell 5806 W3. ADEMCO Honeywell 5806 W3 9 страниц. Smoke & heat detector
Печатать страницу
Smoke & Heat Detector Troubleshooting
Thermal
Off
o
Alarm (>135 )
Freeze
Trouble
Off
o
(<41 F>)
Low Battery
Off
0-7 days
Low Battery
Off
8+ days
Blinks every 5
Power Up
seconds
https://alpha.adt.com/help/89[11/12/2018 9:58:31 PM]
Blinks every 4
Pattern
seconds
Blinks every 10
Off
seconds
Blinks every 45
Off
seconds
Blinks every 45
Chirp every 45
seconds
seconds
Blinks every 5
Off
seconds
smoke or particles. If the device still
indicates a problem, it may be
necessary to clean it. Please refer to
Caring for Your Smoke Detector
below.
The unit has detected that the
temperature is above 135 F. ADT
has been contacted. Press the
recessed test switch to silence the
smoke detector sounder for 5
minutes. If necessary, silence the
alarm keypad.
Remove the source of the heat, if it
can be done safely.
The unit has detected that the
temperature is below 41 F, which
could lead to a freeze situation
within the premises. Investigate the
cause and resolve.
The battery power is low. ADT has
been contacted. You will be notified
of the non-emergency situation.
Replace the battery. Please refer to
the
Smoke and Heat Detector
Battery Replacement
page.
The battery power has been low for
8 or more days. Press the Test
switch to silence the chirp for 12
hours. ADT has been contacted. You
will be notified of the non-
emergency situation. Replace the
battery immediately. Please refer to
the
Smoke and Heat Detector
Battery Replacement
page.
The device is powering up. The lights
will blink for approximately 20
seconds until the unit has
completed the power up cycle.
o
o