ADEMCO 5869 Руководство по установке и настройке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке и настройке для Передатчик ADEMCO 5869. ADEMCO 5869 4 страницы. Holdup switch/transmitter
Печатать страницу
MOUNTING
HOLE
COVER
SCREW (2)
No. 6x1/2
MOUNTING
SCREW (2)
No. 6X2
THIS DEVICE MUST BE PERMANENTLY
MOUNTED WITH THE SCREWS SUPPLIED.
Figure 3. Typical Holdup Switch Installation
BATTERY REPLACEMENT
BATTERY CAUTION :
Risk of fire, explosion, and burns. Do not recharge, disas-
semble, heat above 100°C, or incinerate. Dispose of used
batteries promptly and properly. Keep away from children.
IMPORTANT: When servicing the device for battery
replacement, note that with the mounting screws
removed the case is held in place by the tamper release
tab. Exercise caution not to jar the case while replacing
the battery, possibly breaking the Tamper breakaway
tab.
1.
Remove the two screws securing the cover and two
mounting screws as shown in figure 1.
NOTE:
Use care not to bend the antenna while
attempting to remove or install the battery.
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are
vital to continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to
the user, as well as acquainting the user with the proper operation and limitations of the alarm system and its
component parts. Recommendations must be included for a specific program of frequent testing (at least
weekly) to insure the system's operation at all times.
BREAKAWAY
TAMPER
SCREW
No. 6X3/4
MOUNTING
COVER
SCREW (2)
No. 6x1/2
IMPORTANT:
2.
Remove faulty battery and dispose of properly.
3.
Observing correct polarity (negative side of the battery
facing the trigger), insert the battery into the battery
holder as shown in Figure 1.
4.
Reinstall two cover screws and two mounting screws as
shown in Figure 1.
SPECIFICATIONS
Physical
Battery
MOUNTING
HOLE
Frequency
Reset Key:
Agency:
SCREW (2)
No. 6X2
TO THE INSTALLER
- 2 -
1-15/16"W x 5-15/16"H x 1-3/16"D
(50mm x 150mm x 30mm)
3-volt Lithium. ADEMCO 466, Duracell
DL123A, Panasonic CR123A, Varta CR123A.
345MHz
Supplied, Part Number K4563 to order
separately
UL 636 – Holdup alarm units and systems
US
C
R
LISTED