Autool AST618 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Сервисное оборудование Autool AST618. Autool AST618 8 страниц. Pulsating brake oil exchanger
Печатать страницуHow to Adjust the Working
Pressure Correctly
The working pressure of the pressure regulator has been set
as 1~1.5 bar before delivery, to ensure that the car reservoir
tank will not deform while changing the fluid, thereby
guaranteeing the sealing performance of the secondary
sealing ring. In addition, it allows you to exhaust the air or
change the liquid at a relatively low working pressure by
adjusting the pressure and the switch. Under the special
circumstances, while operating at a relatively high working
pressure, the pressure is not supposed to be too high,
which may damage the clutch master cylinder of the braking
system.
Low-pressure Sealing Performance
Test
By using this (smart)brake fluid replacement machine, you
can exhaust the air and fill the fluid for your brake. You can
also perform low pressure detection on the hydraulic brake.
The device can be connected to the car reservoir tank
through an adapter. Please close all the air valves before the
connection. The air in the braking system is pressurized by
the working pressure of the device (to the pressure required
by the specific car model). Please check the master cylinder
and the braking pipelines in case there is any leakage. If the
brake fluid overflows, it means the braking system is not
completely sealed.
5
Operation Instructions
Note: It's not necessary to start the vehicle.
Lift the car to a proper height to make the driving wheels
off the ground.
Connect the four oil tanks of the device to the car clutch
slave cylinder, and loosen the exhaust screws to ensure
there is oil flowing out.
Pour 2 liters of new brake fluid into the fill port of the
device, and connect the adapter that matches the car
model with the port of the brake fluid reservoir of the car
master cylinder.
Connect the device to a 12V car battery and turn on the
power switch.
Press the "START" button to change the brake fluid.
When changing the fluid, please pay attention to the port
of brake fluid reservoir, if the process is too slow, press
the "Accelerate" button and if it's too fast, press the
"Decelerate" button to slow it down.
After the oil change finishes, the used oil in the tank of
the equipment must be completely drained. If it's not
emptied, the vacuum pump will be damaged and the oil
change process will fail.
Reminder:
Please check each connection parts when changing the fluid
to see if there is oil leakage and whether the connecting
hose is damaged. Please keep the oil fill port clean.
6