Autopilot APCECOD Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Контроллер Autopilot APCECOD. Autopilot APCECOD 17 страниц. Deluxe digital co2 controller

Page 2

APCECOD

Installation

Secure the unit to a wall.

Determine the best location for the remote probe. Place the probe

in an area with good air movement preferably at plant height.

Avoid placing the probe in direct sunlight or under direct HID

Lighting.

Note: Do not place the sensor probe where it will come in to

contact with water. The probe is NOT WATER PROOF!

The remote probe has a quick disconnect to easily remove or

connect the probe. Secure the quick disconnect to the unit by

securing the QD screw to the unit.

Plug the power cable into a standard NEMA 5-15 wall outlet. A

120 volt power supply is required.

Turn the power on and allow it to warm up. This takes about 5

minutes. During the warm up period, the display will read

CO2

heat.

Note: Now is the time to customize your settings prior to

connecting any equipment.

Ensure that the device being connected to the controller has the

proper voltage and will not exceed the maximum amperage rating

of this unit.