Autopilot APCET Инструкции - Страница 4

Просмотреть онлайн или скачать pdf Инструкции для Контроллер температуры Autopilot APCET. Autopilot APCET 4 страницы.

Q & A

How can I tell if the photocell is working? There is a built-in 20

second time delay for the photocell to change status. A green

LED on the top RIGHT edge of the unit that says "Daytime" will

light up when the photocell is in Daytime mode.

Can I connect more than one device to the unit. Yes... As long

as the total amperage of the devices connected to the unit do not

exceed the maximum rating of the unit. We recommend the total

amps not to exceed 75% of the rating.

The temperature of the area does not seem to be correct?

The sensor is located on the bottom on the unit in the protective

plastic "cage". Ensure the unit is not being affected by other

factors such as direct sunlight exposure or areas that may not

have good air movement.

What if there is no power? Ensure the unit is getting power.

Check the device that is connected to the unit by plugging it

directly into a known power supply. If the unit will not turn on and

no LEDs will illuminate, contact your distributor for repair and

warranty issues.

Why are the red and yellow LED lights blinking and no

power? The blinking lights tell user the unit is in over current

protection mode. It may be caused by large load current. Please

unplug the unit and plug in again to resume the normal operation.

If the user does not re-plug the unit, it will attempt to re-power

itself after 10 minutes. After the error is reset, the unit will resume

the normal operation.

Made in China