Autopot 48Pot System Мануалы по установке - Страница 2
Просмотреть онлайн или скачать pdf Мануалы по установке для Система орошения Autopot 48Pot System. Autopot 48Pot System 2 страницы.
Печатать страницу
48Pot system contents
• 1x 400 litre FlexiTank
• 1x 16mm cross connector
• 48x 1Pot tray and lid
• 24x 16 - 6mm cross connector
• 48x 15 litre pot
• 20 metres of 16mm pipe
• 48x AQUAvalve
• 24 metres of 6mm pipe
• 1x 16mm click-fit tank adapter and filter
• 48x marix disc
• 3x 16mm inline tap
• 48x root control disc
Suggested layout
System requires minimum
400 litre FlexiTank (supplied)
400 ltr
FlexiTank
400 ltr
FlexiTank
Elevate tank
150mm from
floor to maintain
gravity pressure
AQUAvalve
16mm click-fit tank adaptor & filter
6mm pipe
16mm pipe
•
Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10
days before turning your system on. This will encourage a stronger and healthier root system.
•
Always raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
•
For best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency
to block small pipe work.
•
Clean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
•
Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
16mm – 6mm cross connector
16mm cross connector
16mm in-line tap
Advice
1Pot dimensions
1
Put black marix
disc in pot
3
Remove collar
Push 6mm pipe through
collar and attach to
AQUAvalve nozzle
Rescrew collar - DON'T
overturn... when you
feel it grip STOP
5
Position tray
so it is level
Insert root control
disc Gold face up
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
1Pot setup
instructions
400 ltr
FlexiTank
680mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
Connect AQUAvalve
so 'half moon' is on
T section in the tray
6
Cut 6mm/16mm pipe
to appropriate length
8
Place
pot
in
the
tray, make sure it is
CLEAN!
Place lid over valve
onto tray