AGS Merlin GDP2 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Измерительные приборы AGS Merlin GDP2. AGS Merlin GDP2 12 страниц. Safe area gas detector controller
Также для AGS Merlin GDP2: Руководство по эксплуатации и установке (7 страниц), Установка, эксплуатация и обслуживание (12 страниц)

Merlin GDP2

3.7

Zones 1-2 Dip-Switches

There is a set dip-switches located on the PCB of the Merlin GDP2 labelled

[ZONE 1] & [ZONE 2].

This is factory set in the 'off' position.

For each of the gas detector zones you are using please ensure that the

relevant zone has being enabled. The zones you are not using should be left

disabled.

When the system is connected to the mains supply, the Power LED will illuminate.

When no power is present, this LED will not light up.



Gas on

On start up the Gas on LED will flash for one minute to check for gas being detected. If there is

no gas detected or any other faults the gas valve will open and the green 'Gas On' LED will

illuminate. If the test is unsuccessful the relevant zone LED light will illuminate to indicate a fault.

GREEN = Gas On

OFF = Gas Off



EM Stop

If an emergency shut off button (either remote or on the panel) is pressed, the LED will

illuminate AMBER and the gas will be turned off.

The EM Stop button must be re-set before restarting the system.

OFF = OK

AMBER = EM Stop button pressed



Heat Detector

Under normal working conditions this LED is off. If the fusible link melts at 72 Degrees Celsius or

higher, the LED will show AMBER and the Gas valve will turn off.



Fire Alarm Panel

If the fire alarm panel has been activated, the LED will illuminate Amber and the gas will be

turned off. The Fire alarm panel must be re-set before restarting the system.

Off = OK

AMBER = Fire alarm activated.

Zones 1-2



GREEN - Under normal working conditions.



AMBER - If the external detector connected detects the low level alarm.



RED - If the detector connected detects high level alarm. The gas valve will close.

Rev: 05 05-19

User Guide