AIRFLO AFI01 Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Льдогенератор AIRFLO AFI01. AIRFLO AFI01 5 страниц.

The Trent & Steele Ice Maker makes 12 pieces of ice cubes in 10 minutes in different ice sizes (small,

medium, large)

IMPORTANT SAFETY REMINDERS



Do not turn the Ice Maker upside down as this may damage the compressor and sealed system. When

transporting, do not incline on over 45° angle.



Remove all packing material and carefully check your Ice Maker to ensure it's in good condition and that

there is no damage to it or the power cord and plug.



The Ice Maker should be placed horizontally on a level surface. To ensure proper ventilation for your Ice

Maker, allow 150mm of space at the top, the back and on each side. Do not install the Ice Maker near an

oven, radiator, or any other heat source.



Before using the Ice Maker for the first time: Wait 2 hours after you have positioned it. Have the lid

open as well.



Ensure that the voltage indicated on the Ice Maker corresponds with the voltage in your house.



For the first three cycles, the ice may be small and irregular in size.



If no water is pumped out to the water tray over two cycles, open the drain cap and let several drops of

water drain out.

START:

Press to switch unit on. This button is also used to start the ice making cycle.

STOP:

Press to switch unit off.

SELECT:

Ice size selection (S) small, (M) medium or (L) large. (Note: The selected mode will stay as

selected unless changed or a power failure occurs. The default setting is medium).

DEFICIENT: This light will come on with a long beep. You will need to add water and press the 'STOP' then the

'START' button to restart the Ice Maker.

ICEFULL:

This light will come on with a beep when the ice has reached the maximum capacity of the

storage cabinet. Press 'STOP' button then press 'START' button to restart the Ice Maker after some of the ice is

scooped out.

HOW TO USE YOUR ICE MAKER

STEP 1. Open the lid and fill the water reservoir with water.

Note: Make sure the water level in the water reservoir is not over the ice collecting tray.

The sensor of temperature