IKEA LIVSLAGA Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Варочная панель IKEA LIVSLAGA. IKEA LIVSLAGA 24 страницы. Burner
Также для IKEA LIVSLAGA: Руководство пользователя (40 страниц), Инструкция по сборке Руководство (20 страниц), Руководство пользователя (20 страниц)

Печатать страницу

ENGLISH

Electrical connection

WARNING

This operation must be performed by

a qualified technician or authorised

person.

The electrical connections must comply

with local regulations.

The earthing of this appliance is

compulsory by law.

Do not use an extension cord.

- IMPORTANT: the data relevant to the

voltage and power absorption are

indicated on the rating plate.

Assembly

After having cleaned the perimeter surface,

apply the supplied gasket to the hob.

Position the hob in the worktop opening

made respecting the dimensions indicated

in the Instruction.

NOTE: the power supply cable must be long

enough to permit its upward extraction.

To secure the hob, use the brackets provided

with it. Fit the brackets into the relevant

bores shown by the arrow and fasten them

by means of their screws in accordance with

the thickness of the worktop.

Make sure that the outlet is near the product

to install. So, if the cable that came with the

product is not long enough, you will need to

replace it with another one having the same

features but with the right length.

Adjustment to different type of gas

WARNING

This operation must be performed by

a qualified technician or authorised

person.

Earth

(yellow/green)

If the appliance is intended to operate with

a different gas from the gas type stated on

the rating plate and information label on

the top of the hob, change the injectors.

Remove the information label and keep it

with the instructions booklet.

Use pressure regulators suitable for the gas

pressure indicated in the Instruction.

Ensure to remove the natural gas regular

device and replace with the propane / lpg

test point adaptor.

The gas nozzles must be changed

by After Sales Service or a qualified

technician or authorised person.

Nozzles not supplied with the appliance

must be ordered from After Sales

Service.

Adjust the minimum setting of the taps.

NOTE: when liquid petroleum gas is used

(eg. G30/G31), the minimum gas setting

screw must be tightened as far as it will go,

or until the flame is small and stable enough

to keep it alive.

IMPORTANT: should you experience

difficulty in turning the burners knobs,

please contact the After Sales Service for

the replacement of the burner tap if found to

be faulty.

Replacing the injectors (see paragraph

"injector table")

Remove grids (A).

Extract burners (B).

Using a socket spanner of the

appropriate size unscrew the injector

(C), unscrew the injector to be replaced.

Replace it with the injector suitable for

the new type of gas.

Re-assemble the injector in (D).

Before installing the hob, remember to affix

the gas calibration plate supplied with

the injectors in such a way that it covers

the existing information relating to gas

calibration.