Avantco 178APT48HC Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Холодильник Avantco 178APT48HC. Avantco 178APT48HC 13 страниц. Commercial refrigerator
Печатать страницу
Installation
Important!!! Please Read Before Installation
•
If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to promote
proper air flow. Failure to install the shelves properly is considered user-error and is not covered by
warranty.
• If the unit has recently been transported on its side, please let unit stand still for a minimum of 24 hours
before plugging it in.
• Make sure that the unit drops down to desired temperature before loading the unit with product.
• Make sure that there is proper ventilation around the unit in the area where it will operate.
• Make sure all accessories are installed (i.e.. Shelves, shelf clips, casters) before plugging the unit in.
• Please read through the manual in its entirety.
Cabinet Location Guidelines
•
Install the unit on strong and leveled surfaces
- Unit may be noisy and/or malfunction if surface is uneven.
•
Install the unit in an indoor, well-ventilated area
-For best performance, please maintain clearance of 4" on the back of the unit. Brackets should be attached on the
back of the unit.
- Outdoor use may cause decreased efficiency and damage to the unit.
• Avoid installation in a high humidity and/or dusty area
- Humidity could cause unit to rust and decrease efficiency of the unit.
- Dust collected on condenser coil will cause unit to malfunction.
- Malfunction due to dirty condenser will void warranty.
•
Select a location away from heat and moisture-generating equipment
- High ambient temperatures will cause the compressor to overwork, leading to higher energy bills and gradual
breakdown of the unit.
-With the lid open, the unit should not be used in areas over 80 degrees. The unit should not be used in areas over 90
degrees.
-Malfunction due to high ambient temperature will void warranty.
•
For optimal performance, 3" of clearance is required around all louvered or vented panels, to allow for
proper air flow
-For your convenience, a set of brackets is included to prevent this unit from being pushed up against a wall
-Component failure due to improper installation is not covered under warranty.
User Manual
- 3 -