Fujitsu AB G18LVTB Series Руководство по проектированию и техническим вопросам - Страница 25
Просмотреть онлайн или скачать pdf Руководство по проектированию и техническим вопросам для Кондиционер Fujitsu AB G18LVTB Series. Fujitsu AB G18LVTB Series 45 страниц.
Печатать страницу
CONTENTS OF FUNCTION SETTING
•
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
•
The settings may be selected between the following two: Function Number or Setting Value.
•
Settings will not be changed if invalid numbers or setting values are selected.
1-1
1-2
1-3
Cooler room temperature correction
1-4
Heater room temperature correction
1-5
1-6
Indoor room temperature sensor switching function
1-7
1-8
1-1. Filter sign
The indoor unit has a sign to inform the user that it is time to clean the filter. Select the time setting
for the filter sign display interval in the table below according to the amount of dust or debris in the
room. If you do not wish the filter sign to be displayed, select the setting value for "No indication".
Setting Description
"Standard
(400 hours)"
"Long interval
(1,000 hours)"
"Short interval
(200 hours)"
No indication
1-2. Ceiling height
Select the setting values in the table below according to the height of the ceiling.
Setting Description
Standard
High ceiling
1-3. Cooler room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Lower control
Lower control
Warmer control
When using floor console installation, change the setting value to "1".
Filter sign
Ceiling height
Auto restart
Remote controller signal code
External input control
Function Number
11
Function Number
20
Function Number
30
- (01 - 22) -
( . . .Factory setting)
Setting Value
00
01
02
03
( . . .Factory setting)
Setting Value
00
01
( . . .Factory setting)
Setting Value
00
01
02
03