For Wireless Network Users
f
Connect the USB cable directly to the
computer and the machine (you must remove
the USB cable in step l, on this page).
g
Do one of the following:
If the Installation confirmation screen
appears, check the box and click Next, go
to h.
Otherwise, go to i.
h
Check Yes if you want to connect with the listed
SSID. Click Next and go to k.
i
The wizard will search for wireless networks
available from your machine. Choose the SSID
that you wrote down for your network in step
20-a on page 26, and then click Next.
Note
• If the list is blank, check that the wireless access
point/router has power and is broadcasting the
SSID, and then see if the machine and the
wireless access point/router are within range for
wireless communication. Then, click Refresh.
• If your wireless access point/router is set to not
broadcast the SSID you can manually add it by
clicking the Advanced button. Follow the
on-screen instructions for entering the Name
(SSID), and then click Next.
j
Enter the Network Key you wrote down in step
20-a on page 26, and then click Next.
Note
If your network is not configured for
Authentication and Encryption, the ATTENTION!
screen will appear. To continue configuration,
click OK.
k
Confirm the wireless network settings and then
click Next. The settings will be sent to your
machine.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.
l
Disconnect the USB cable between the
computer and the machine and then click Next.
Wireless setup is now complete. A four
level indicator at the top right of your
machine's LCD will show the wireless
signal strength of your wireless access
point/router.
To install the MFL-Pro Suite, continue to
step 23-e on page 38.
Now go to
page 38
29
Печатать страницу