Brother DSmobile DS-740D Руководство по быстрой настройке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по быстрой настройке для Сканер Brother DSmobile DS-740D. Brother DSmobile DS-740D 10 страниц.
Также для Brother DSmobile DS-740D: Руководство по быстрой настройке (11 страниц)
Печатать страницу
Product Safety Guide
How to remove
and dispose of the
rechargeable Li-ion battery
(DSmobile DS-940DW only)
Turn off the machine and remove the USB cable from the
machine before removing the rechargeable Li-ion battery.
1. P lace the machine face down and remove the Side
Cover using a flathead screwdriver.
2. D isconnect the rechargeable Li-ion battery connector
from the Printed Circuit Board Assembly (PCBA). Do
not disconnect the Flexible Flat Cable (FFC).
3. P ush the release tab (as illustrated) to remove the
rechargeable Li-ion battery from the Side Cover.
4. C over the rechargeable Li-ion battery terminals with
tape and dispose according to your local recycling laws.
2
3
NOTE
• We do not recommend removing the rechargeable
Li-ion battery unless disposing the scanner.
• For more information about handling the
rechargeable Li-ion battery, see the applicable
instructions and warnings in this guide.
Regulation
IMPORTANT
• Brother cannot accept any financial or other
responsibilities that may be the result of your use
of this information, including direct, special or
consequential damages. There are no warranties
extended or granted by this document.
• This machine has been certified to comply with
FCC standards, which are applied to the USA only.
8
1
4
Federal Communications
Commission (FCC)
supplier's Declaration of
Conformity (For USA Only)
Responsible Party:
Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
declares, that the products
Product Name: DSmobile DS-640, DSmobile DS-740D,
DSmobile DS-940DW
complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
(DSmobile DS-940DW only)
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
IMPORTANT
• Changes or modifications not expressly
approved by Brother Industries, Ltd. could void
the user's authority to operate the equipment.
• A specific shielded interface cable should be
used to ensure compliance with the limits for a
Class B digital device.