Acapella Audio Arts Duke Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Динамики Acapella Audio Arts Duke. Acapella Audio Arts Duke 9 страниц.

Attention: If King does not accept any operating function, a reset of the control of the microprocessor could be

necessary. Disconnect the unit from the power source (Reset) and plug it in again after approx. 30 seconds.

Whenever the power cord is connected to the outlets, an energy-saving mode is activated to maintain the high quality

of King. This ensures best performance after start-up of the system and increases the longevity of the unit.

King

Buttons

Press the bottom !

• Left

more low

• Center

on, input two selected/off

• Right

louder

LED´s

lower rank, three LED's, input display

• Left

input 1 active

• Center

input 2 active

• Right

input 3 active

• Upper series, five tri-colored LED's, volume display,

indicating as a running light, beginning with green = low

volume across yellow = medium to red = loud.

• When the muting button on the remote control is

activated, the indicator LED of the selected volume will

blink.

Rear panel

• Socket A = power connector equipped with a locking

clamp and voltage selector. Please make sure that the

preset voltage is correct. If the component shows no

function, check the fuse. A spare fuse (2A slow blow) is

located in the clamp.

• Socket B = input connectors, from the left side to

the right 1-2-3.

Left channel = white above, right channel = red below.

• Socket C = outputs for Duke's. Connect them with the

supplied special cable (XLR). Looking from the front

panel right side = right Duke, left side = left Duke.

• Socket D = Connection of remote control synchroncable.

(Please connect them with the supplied cable to socket „D"

at QUEEN)