Aqua Flo 160198 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Aqua Flo 160198. Aqua Flo 160198 4 страницы. High-flow whole house filtration system

Печатать страницу

OPERATION

With sufficient pressure, this system operates automatically. To

ensure it operates dependably, you need to perform periodic filter

changes and monitor system pressure differential as outlined in the

maintenance instructions.

INSTALLATION

* Please note: all cartridge filters are pre-installed in the

housings at the factory.

1. Turn off all equipment to be fed by the system. Locate the water

supply shutoff valve to your home or RV and turn it off.

2. Thread the inlet and outlet fittings into the inlet and outlet of the

system.

NOTICE

DO NOT OVERTIGHTEN THE

FITTINGS INTO THE FILTER HEADS.

3. Anchor the system on a wall stud or suitable mounting material

spanning wall studs. System must be vertical, upright and level.

4. Run a suitable line of at least 1⁄2" in diameter from the tap water

source to the inlet on the left side of the system.

NOTICE

DO NOT OVERTIGHTEN WATER CONNECTION

FITTING INTO THE SYSTEM.

6. Select the appropriate size tubing for the equipment being fed

and connect it to the outlet fitting of the system.

NOTICE

DO NOT OVERTIGHTEN CONNECTION FITTING INTO THE SYSTEM.

7. Once all inlet and outlet piping has been completed, check and

make sure all filter housings are tight. Slowly open the inlet valve

to house or RV and allow the system to reach operating pressure.

Check for leaks.

8. Record the startup date for future filter replacements.

NOTICE

Overtightening components can damage the system causing

water damage and/or system failure.

MAINTENANCE

Routine maintenance of this system involves periodic filter changes.

Cartridges should be changed at least every 6 months or sooner

depending on incoming water quality.

Filter Cartridge Replacement Procedure

IMPORTANT: Determine whether all equipment connected

to the system must be turned off prior to shutting off water

supply from filters

1. If required, turn off downstream equipment.

2. Turn OFF water supply to the system and open faucet to relieve

pressure.

3. Starting with the housing on the left, unscrew housing by

turning counterclockwise. Remove and discard spent filter and

drain water that remains in the bowl. The sediment cartridge

must be in the 1st housing on the left where water inlet

connects. Continue on to the 2nd housing, the carbon block filter

has a rubber gasket on each end.

4. Clean inside of housing sump with warm water. If desired,

disinfect housing using a teaspoon of household bleach. Add to

filter bowl and fill with water. Let stand 5 minutes and then

discard and rinse.

5. Insert new cartridges into filter housings, making sure filters are

installed from left to right, sediment filter then carbon block

filter.

NOTICE

Do not overtighten filter housing. Overtightening may

damage o-ring(s), cause water leaks,

or affect system performance.

6. Lubricate o-ring using only a NSF approved silicone grease.

Check o-ring for damage and replace if damaged or distorted.

Make certain the o-ring is properly positioned and reinstall filter

housings. Tighten housings hand tight.

7. Slowly turn on water supply to restore water flow to water

system and check for any leaks.