AVPro Edge AC-EXO-444-KIT Краткое руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Удлинитель AVPro Edge AC-EXO-444-KIT. AVPro Edge AC-EXO-444-KIT 4 страницы. 4k hdmi extender via optical fiber; up to 2 kilometer

Печатать страницу

EDID Management:

Quick press the settings button to select desired EDID setting.

1. EDID BYPASS --- LED Flashes 1 Time (Default, from downstream device)

2. 1080P_2CH --- LED Flashes 2 Times

3. 1080P_8CH --- LED Flashes 3 Times

4. 4K60HzY420_3D_2CH --- LED Flashes 4 Times

5. 4K60HzY420_3D_8CH --- LED Flashes 5 Times

6. 4K60Hz_3D_2CH_HDR--- LED Flashes 6 Times

7. 4K60Hz_3D_8CH_HDR --- LED Flashes 7 Times

8. USER EDID --- LED Flashes 8 Times

While in the USER EDID state (8), press and hold the setting button (for 4 seconds) in order to copy

the EDID from the connected display or downstream device to the user EDID and it will apply auto-

matically.

Why do this?

This is used when there is a need for a specific, known EDID that the installer may prefer. It can also

be used if you want to bypass an EDID of an AVR or another connected device.

Scaler Setting:

While in ANY setting besides the USER EDID, press and hold the setting button (for 4 seconds) to

toggle the scaler mode.

The options are:

1. Normal Mode (ICT Mode) --- LED Flashes 1 Time

2. Down Scaler Mode (4K->2K) --- LED Flashes 2 Time

RS-232 Configuration

RS-232 can be used to pass control signals bi-directionally to & from any RS-232 compatible device.

This is commonly used to route control signals in the following way:

1. Control System --> Display/Projector (i.e., Power On/Off)

2. Display/Projector --> Control System (i.e., Display Status, Volume Status etc...)

3. When ultra long-range serial communication is needed (think concerts, live events). Use the

extender.

IR Configuration

IR can be used in three ways:

From Rack (Control System Direct): Plug a 3.5mm cable into an emitter port of any con-

trol system directly into the "IR IN" port on the AC-EXO-444 Transmitter to pass IR signals directly to

the remote end. NOTE - Be sure the IR MODE Slide Switch is set to "I-PASS" on the Transmitter