Dell Force10 S50N Series Краткое руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сервер Dell Force10 S50N Series. Dell Force10 S50N Series 25 страниц. Rapid equallogic configuration series configuration introduction array: ps4100 host: vmware esxi
Также для Dell Force10 S50N Series: Руководство по внедрению (9 страниц)

Печатать страницу

Installing the Hardware

This guide assumes all site preparation has been performed before installing the

chassis.

Installing the Chassis

To install the S50 chassis, Dell Force10 recommends that you complete the

installation procedures in the order presented below.

NOTE: Unless stated otherwise, the installation instructions below apply to both

the S50N and S50V chassis.

Always handle the system and its components with care. Avoid dropping the

switch or its field replaceable units.

CAUTION: Always wear an ESD-preventive wrist or heel ground strap when

handling the chassis and its components. As with all electrical devices of this

type, take all necessary safety precautions to prevent injury when installing

this system. Electrostatic discharge (ESD) damage can occur if components

are mishandled.

Installing the Chassis in a Two-Post Rack

The chassis is shipped with the universal front-mounting brackets (rack ears)

attached. Ensure that there is adequate clearance surrounding the rack to permit

access and airflow.

The S50N and S50V chassis can be installed using several methods. This

document describes the most common installation method: two-post rack. For

information regarding other installation methods, refer to the

guide.

S50V Systems

This document does not include stacking or installing stacked units. Refer to the

Installing S50N and S50V Systems

cabling.

guide for details on stacking installation and

Installing the Hardware

Installing S50N and