Dell PowerEdge 1300 Руководство по обновлению - Страница 16
Просмотреть онлайн или скачать pdf Руководство по обновлению для Сервер Dell PowerEdge 1300. Dell PowerEdge 1300 23 страницы. Video update
Также для Dell PowerEdge 1300: Руководство по обновлению (24 страниц), Руководство по обновлению (2 страниц)
Печатать страницу
support.dell.com
microprocessor
!
!" #
!
$
%
To remove the guide bracket assembly, perform the following steps:
1.
Remove any terminator card installed in the guide bracket.
2.
Remove any microprocessor assembly installed in the guide bracket.
3.
Use a #2 Phillips screwdriver to loosen the four captive nuts that secure the
guide bracket assembly to the system board (see Figure 1-5).
4.
Lift up the assembly to remove it from the four threaded posts.
To install the new guide bracket assembly, perform the following steps:
1.
Position the guide bracket over the four threaded posts (see Figure 1-6).
You can install the guide bracket only one way (the captive nuts will not align
with the threaded posts if installed incorrectly).
2.
Tighten the four captive nuts using a #2 Phillips screwdriver.
Dell PowerEdge Systems — Microprocessor Upgrade
release latches (2)
thumbscrews (2)
heat sink
1-13