Dell PowerEdge 2410 Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Сервер Dell PowerEdge 2410. Dell PowerEdge 2410 8 страниц. Cabling poweredge t610
Также для Dell PowerEdge 2410: Руководство (20 страниц), Руководство (20 страниц), Руководство (17 страниц), Руководство (12 страниц), Руководство (10 страниц), Руководство (10 страниц), Руководство (9 страниц), Руководство (9 страниц), Руководство (10 страниц), Руководство (12 страниц), Руководство (11 страниц)

Cable Routing Procedures for Dell™ PowerEdge™ T610 Systems

Section 3: Replacing a Power Supply on a PowerEdge™ T610 System With a

CMA

NOTE: The steps described below apply to the bottom power supply only when the CMA is installed

to the left side. If the CMA is attached to the right side, both power supplies can be removed without

removal of the CMA. If the CMA is attached to the left side, the top power supply can be replaced with

the CMA in its closed (retracted) position.

Swing the CMA to its service position.

2. Disengage the strain relief and disconnect the power cord from the power supply.

3. Disconnect the inner CMA attachment housing from the rail as shown in Figure 8.

4. While supporting the CMA with one hand, remove and replace the power supply with the

other hand as shown in Figure 8.

5. Reconnect the CMA attachment housing to the rail.

6. Plug in the power cord, re-engage the strain relief, and return the CMA to the closed

(retracted) position.

Inner CMA attachment housing

has been disconnected.

Page 6