Dell 2000FP Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Монитор Dell 2000FP. Dell 2000FP 50 страниц. Dell 2000fp lcd monitor
Также для Dell 2000FP: Руководство по установке (10 страниц), Руководство по быстрой настройке (4 страниц), Руководство по быстрой настройке (4 страниц), Руководство по эксплуатации (6 страниц)
Печатать страницу
Dell 2000FP LCD Monitor Service Guide
2.2.2 SIGNAL INTERFACE
(1) Analog input
(2) TMDS input
(3) Video input
(3) Sync input
(3) Signal cable
(4) Abnormal signal immunity
(5)Warm-up time to stabilize the I/F setup
2.2.3 MODES AND TIMING
(1) Synchronization range
Length and color
Pin assignment
Level
Impedance
Pin assignment
Level
Impedance
Pin assignment
Level
Impedance
Type
Level
Impedance
Analog
Digital
Video
3
Confidential
Engineering Specification
With length of 1800mm, black color.
See Appendix 1 – Analog connector
0.7 volt ± 5%
75 ohm. TDR scan needed for both D-SUB cable and
interface board.
See Appendix 1 – DVI-D Connector
600mV for each differential line.
50 Ohm. TDR Scan needed for DVI cable and interface
board.
See Appendix 1 – Video connector
(S-VIDEO) Y input: 1 volt (p-p)
(S-VIDEO) C input: 0.286 Volt (p-p)
(COMPOSITE) 1 volt (p-p)
(S-VIDEO) Y input: 75 ohm
(S-VIDEO) C input: 75 ohm
(COMPOSITE) 75 ohm
Monitor accepts separate Horizontal, Vertical sync,
composite sync, and SOG.
Monitor accepts positive and negative sync. signal from
both 3.3V and 5V TTL families. Inputs sense a logic 0
when the input absolute value is 0.8 V or less and logic 1
when the input absolute value is 2.3V or greater.
2.2KOhm min (pull down)
Detachable, shielded 2.0 meters (6.67 ft), D-SUB 15P
male connector, with blue connectors, thumb screws and
black color.
Detachable, DVI-D, white connectors, 2.0 meters (6.67
ft) and black color.
S-VIDEO, COMPOSITE-video, w/o audio. Cables are not
included.
The monitor cannot be damaged by improper sync, timing
pulse duration, or absence of sync, or abnormal input
signal amplitude (video and/or sync too large or too
small), or any other anomalous behavior of a graphics
card or video generator when changing modes, or when
any combination of input signals is removed or replaced.
Additionally, under these conditions, the monitor cannot
cause damage to the source.
Image is considered to be ready for correct position and
timing adjustment after 3 minutes maximal warm-up time.
Horizontal frequency range: 31 to 80KHz