Dell 210-ALUI Руководство пользователя - Страница 45
Просмотреть онлайн или скачать pdf Руководство пользователя для Монитор Dell 210-ALUI. Dell 210-ALUI 48 страниц.
Печатать страницу
Common problems
The following table contains general information about common monitor problems
you might encounter and the possible solutions:
Common Symptoms
No Video/Power LED off
No Video/Power LED on
Poor Focus
Shaky/Jittery Video
Missing Pixels
Stuck-on Pixels
Brightness Problems
Geometric Distortion
Horizontal/Vertical Lines
∞ Ensure that the video cable connecting the monitor and the
computer is properly connected and secure.
∞ Verify that the power outlet is functioning properly using any
other electrical equipment.
∞ Ensure that the power button is pressed.
∞ Ensure that the correct input source is selected via the
Source
menu.
∞ Increase brightness and contrast controls using the OSD.
∞ Perform monitor self-test feature check.
∞ Check for bent or broken pins in the video cable connector.
∞ Run the built-in diagnostics.
∞ Ensure that the correct input source is selected via the
Source
menu.
∞ Eliminate video extension cables.
∞ Reset the monitor to Factory Settings (Factory Reset).
∞ Change the video resolution to the correct aspect ratio.
∞ Reset the monitor to Factory Settings (Factory Reset).
∞ Check environmental factors.
∞ Relocate the monitor and test in another room.
∞ Cycle power On-Off.
∞ Pixel that is permanently Off is a natural defect that can occur in
LCD technology.
∞ For more information on Dell Monitor Quality and Pixel Policy,
see Dell Support site at:
www.dell.com/support/monitors.
∞ Cycle power On-Off.
∞ Pixel that is permanently off is a natural defect that can occur in
LCD technology.
∞ For more information on Dell Monitor Quality and Pixel Policy,
see Dell Support site at:
www.dell.com/support/monitors.
∞ Reset the monitor to Factory Settings (Factory Reset).
∞ Adjust brightness & contrast controls via OSD.
∞ Reset the monitor to Factory Settings (Factory Reset).
∞ Adjust horizontal & vertical controls via OSD.
∞ Reset the monitor to Factory Settings (Factory Reset).
∞ Perform monitor self-test feature check and determine if these
lines are also in self-test mode.
∞ Check for bent or broken pins in the video cable connector.
∞ Run the built-in diagnostics.
Possible Solutions
Troubleshooting
Input
Input
45
|