Miele DAR 1230 Инструкции по эксплуатации и установке - Страница 34

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Вентиляционная вытяжка Miele DAR 1230. Miele DAR 1230 40 страниц. Range wall / insert hood
Также для Miele DAR 1230: Инструкции по эксплуатации и установке (32 страниц), Инструкции по эксплуатации и установке (22 страниц), Инструкции по эксплуатации и установке (40 страниц)

Installation

Plywood backing

The majority of the weight of the

installed ventilation system will be

supported by the lower retaining

plate. It must be firmly attached to

the stud framing behind the drywall.

If studs are not available in the

required locations, a plywood

backing (min. ½" (13 mm) thick)

spanning at least two studs must be

installed.

Failure to adequately support the

weight as stated may result in the

ventilation system falling off the wall,

causing personal injury and property

damage.

If plywood backing is not needed,

proceed to the included "Installation

diagram".

 Determine and mark the location for

the canopy  as outlined in

"Appliance dimensions".

 Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the canopy.

 Find the studs  to the left and right

of the mounting location by tapping

the wall or using a stud finder.

 Mark a vertical cutting line along the

center of each stud.

CAUTION: When cutting or drilling

into the wall or ceiling, do not

damage electrical wiring and other

hidden utilities.

 Remove the drywall between the

cutting lines and replace it with

plywood  of a matching thickness

(min. ½" (13 mm) thick). Tape the

joints and refinish the wall.

 Proceed to the enclosed "Installation

diagram" to complete the installation.