ABB ACS880-31 Руководство по быстрой установке и вводу в эксплуатацию
Просмотреть онлайн или скачать pdf Руководство по быстрой установке и вводу в эксплуатацию для Промышленное оборудование ABB ACS880-31. ABB ACS880-31 17 страниц. Converter modules with electrolytic dc capacitors in the dc link
Также для ABB ACS880-31: Руководство (16 страниц)
Печатать страницу
—
ABB INDUSTRIAL DRIVES
ACS880-31
Quick installation and start-up guide
This guide is applicable to the global IEC and NEC North American installations
Documentation in other languages
Safety instructions
WARNING! Obey these instructions. If you ignore them, injury or death, or damage to the equipment can occur. If
you are not a qualified electrical professional, do not do electrical installation or maintenance work.
WARNING! If you activate the automatic fault reset or automatic restart functions of the drive control program,
make sure that no dangerous situations can occur. These functions reset the drive automatically and continue
operation after a fault or supply break. If these functions are activated, the installation must be clearly marked as
defined in IEC/EN/UL 61800-5-1, subclause 6.5.3, for example, "THIS MACHINE STARTS AUTOMATICALLY".
•
Do not do work on the drive, motor cable, motor, or control cables when the drive is connected to the input power.
Before you start the work, isolate the drive from all dangerous voltage sources and measure that there are no
dangerous voltages. Always wait for 5 minutes after disconnecting the input power to let the intermediate circuit
capacitors discharge.
•
Do not do work on the drive when a rotating permanent
magnet motor is connected to it. A rotating permanent
magnet motor energizes the drive, including its input and
output terminals.
•
Make sure that debris from drilling, cutting and grinding.
does not enter the drive.
•
Frames R6 and R8: Use the lifting eyes of the drive when
you lift the drive. Do not tilt the drive. The drive is heavy
and its center of gravity is high. An overturning drive can
cause physical injury.
1. Unpack the drive
Keep the drive in its package until you are ready to install it. After unpacking, protect the drive from dust, debris and
moisture. Make sure that these items are included: drive, mounting template, control panel, quick installation and start-up
guide, multilingual residual voltage warning stickers, hardware and firmware manuals (if ordered), options in separate
packages (if ordered). Make sure that there are no signs of damage to the items.
2. Reform the capacitors
If the drive has not been powered up for a year or more, you must reform the DC link capacitors. See
contact ABB technical support.
Ecodesign information
(EU 2019/1781 and SI 2021 No. 745)
.
About this document
3AXD50000803033 Rev C EN
2022-09-20
© 2022 ABB. All rights reserved.
Original instructions.
Related documents
1
or